2. FLEXCO
  3. FGP Two Piece Mount

FLEXCO FGP Two Piece Mount Operating instructions

  • I've reviewed the instructions for the FLEXCO Mount 56588. This document provides guidance on installing the two-piece mounting bracket for the FGP Food Grade Precleaner, including how to position, trim, and secure the brackets. It also covers ensuring the pole is correctly aligned and the final installation of the cleaner and blade. I'm ready to help answer your questions about this installation process.
  • What is this document about?
    Do I always need to use both pieces of the bracket?
    How should I initially secure the brackets?
    How do i know if the pole is in correct position?
FGP Two-Piece Mount (56588)
Instructions
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 U.S.A.
Telephone: 1-630-971-0150 • Fax: 1-630-971-1180 • E-mail: info@flexco.com
Visit www.flexco.com for other Flexco locations and products.
©2018 Flexible Steel Lacing Company. 02-28-18. For Reorder: X5012
1. Reference FGP Food Grade Precleaner IOM (X3646) for full installation details. is sheet is only to guide the installation of the optional
mounting bracket.
2. Position 2-piece bracket set so FGP Pole center is at correct XYC position. NOTE: it is not always necessary to use both brackets.
3. Trim brackets as necessary, then temporarily clamp or tack-weld the brackets in place. is will allow for future adjustments.
4. Temporarily mount brackets onto opposite side
of conveyor (Fig. A).
5. Test t cleaner without blade. Pole should be parallel to
the pulley (Fig. B).
(Single piece used for bracket)
6. If the pole is in correct position, then nish weld (or bolt-
mount) brackets to conveyor. e 2-piece bracket can be welded or
bolted together using 2 bolts per side (Fig. C).
7. Install cleaner and tension blade appropriately (Fig. D).
(2 pieces used for bracket)
Fig. A Fig. B
Fig. C Fig. D
/