2. Sunricher
  3. SR-2803A

Sunricher SR-2803A User manual

  • Hello! I've reviewed the user manual for the SR-2803A RF Wireless Single/Dual Color Remote. This document outlines the remote's features, including its 6-zone control, single/dual color mode support, and pairing process with RF receivers. I'm ready to assist you with any questions you have about the device or its functionality.
  • What type of battery does the remote use?
    How many zones can the remote control?
    How many remote controls can be paired with one receiver?
    What is the operating temperature range for the remote?
RF Wireless Single Color/Dual Color Remote 09.2803A.04459
Switch between single color mode or dual color mode:
Single color mode: (e.g. zone 4), press and hold down 4
then zone 4 was under single color mode. Under this model, and will not working.
Dual color mode: Choose a zone(e.g. zone 4), press and hold down 4 & together about 5-10 seconds,
then zone 4 was under dual color mode.
Choose a zone & together about 5-10 seconds,
Note:Before the first use, please remove the protective film on the battery.
Function introduction
Important: Read All Instructions Prior to Installation
Output RF signal
Operation Frequency 868/915/434MHz
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 136.3x38.9x10.7mm
Front side
Back side
• Control 6 zones of receivers separately
• Single color/dual color controller
• Compatible with all universal series RF receivers
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Product Data
• This device contains a button lithium battery that shall be stored and disposed properly.
• DO NOT expose the device to moisture.
Safety & Warnings
Power Supply 3V(1xCR2025 battery)
Control the receiver’s channel 1
and channel 3.
Press and hold down to adjust
warm white between 0%-100%
Only work with dual color,
it's useless for single color.
6 zones control.
Click to choose the zone,
Press and hold down to turn
on/off the zone
Control the receiver’s channel 2
and channel 4.
Press and hold down to adjust
cool white between 0%-100%
Only work with dual color,
it's useless for single color.
On/Off
Press and hold down to increase light
intensity smoothly
Press and hold down to decrease light
intensity smoothly
1 2
1
Pair with RF receiver
Step 3:Choose and click a zone number(e.g. zone 4)
Step 2:Click the “Learning Key” button on RF receiver to set it into pairing status
Note: one receiver can be paired with max 8 remote controls.
Learning Key
RF LED Receiver
Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 4:Click any of the four buttons , LED lights connected with
the RF receiver flicker once means the receiver is paired with zone 4 successfully.
If you use multiple receivers, you have two choices:
Option 1: have all the receivers in the same zone, like zone 1
Lear ning Ke y
RF LED Rec eiv er
Zone 1
Option 2: have each receiver in a different zone, like zone 1, 2, 3 or 4
Zone 1 Zone 2 Zone 3
RF remote
RF remote
Lear ning Ke y
RF LED Rec eiv er
Lear ning Ke y
RF LED Rec eiv er
Lear ning Ke y
RF LED Rec eiv er
Lear ning Ke y
RF LED Receiv er
/