BVP 282 Flood Lighting Luminaire
Type : BVP282
Light Source : LED’s
Voltage : 240V, 50-60 Hz
IP Classification : IP-66
Net Weight : 2.4 kg
Application : Outdoor use only
Installation
30 mm
L
N
Red/Brown - Live
Grn-Yel - Earth
Black/Blue - Neutral
8-9 mm
1
23
Mounting Angle
D
C
All dimensions are in mm.
AB
A
Type E
B
A
D
C
E
M8 Screw with spring
washer and flat washer
52100W 203
264 300
160
Gland
Center Line
Note: Mounting Screw Size : M8
Adjust the aiming of the luminaire
and tighten the mounting screws on
the side for locking in position using
a torque of 8 N-m.
Use proper junction box of IP66
protected for termination of the wire
to ensure electrical safety and
product performance.
(Junction Box is not part of the supply)
Installation Instruction
All the pictures in the MI sheet are representative only and may vary from the actual product. All the pictures in the MI sheet are representative only and may vary from the actual product.
Warning
Maintenance
Caution
1. The luminaire shall be installed by a qualified electrician.
2. Turn power off before inspection, maintenance, installation or removal.
3. Refer to technical datasheet for additional electrical properties to ensure safe
installation.
4. Luminaire installed must not be in contact with combustible materials.
5. Ensure power supply cables (L-N-E) are connected correctly before
Switching on.
6. The connection of power cable on luminaire is type Y. If the external flexible
cable or cord of the luminaire is damaged, it shall be exclusively replaced by
the manufacturer or his service agent or a similar qualified person in order to
avoid hazard.
7. The light source of this luminaire is not replaceable, when the light source
reaches its end of life the whole luminaire shall be replaced.
8. Warranty void if earthing is not connected.
1. Periodic cleaning of the luminaire glass cover will ensure max. optical
Efficiency.
2. Luminaire glass cover shall be cleaned with water and non-abrasive
soap, cleaner or detergent solution.
1. The luminaire must be used within the applicable product specifications,
installation instructions and environmental conditions for storage & operations
according to applications guidelines provided by Philips for product Warranty
to be valid.
2. In case the front glass is found broken/ damaged, it should not be powered on
and is to be replaced before using the luminaire.
Caution: Gland shall never be
above the centre line.
Mounting Angle
D
C
All dimensions are in mm.
AB
A
Type E
B
A
D
C
E
52100W 203
264 300
160
Note: Mounting Screw Size : M8
-
1
-
2
Philips BVP282 Tango G2 Gen 4.0 Solar User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Martin Cyclo IP65 Directional User manual
-
-
Martin Cyclo IP65 US User manual
-
-
Martin Cyclo IP65 Series User manual
-
Eaton CROUSE-HINDS NVMV Series Operating Instructions Manual
-
-
Martin Exterior 1200 Wash User manual
-
-