P7191

Polaris Sinks P7191, P059, P159, P519, P564-16, P564-16-ENS, P564-18, P564-18-ENS, P909 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Polaris Sinks P7191 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Installation Instructions
Some models constructed of stainless steel, copper and bronze have the option of being mounted either under or over
the countertop. Their wide and tapered rims allow either type of installation.
The installation steps below apply to both mounting techniques with differences clearly noted where they occur. Mount-
ing below the counter can be done in three different styles. Either style of mounting usually requires clips in addition to a
silicone sealent. Clip styles can vary by mounting style and sink model, as noted in the diagrams below
Using the template provided, measure and cut
the hole in the countertop.
Determine the locations for the clip brackets around
the perimeter of the sink. Pre-drill holes for the clips
using appropriate methods for the countertop material.
With denatured alcohol, clean the surfaces of the sink
and countertop which will meet.
Topmount: Apply a bead of silicone along the top
perimeter edge of the counter opening.
Undermount: Apply a bead of silicone along the
perimeter edge of the openning on the underside
of the counter.
Undermount
or Topmount
Sinks
The Installation of Sinks Which Can Be Undermounted or Topmounted
The Steps
Polaris Sinks © 2015
www.polarissinks.com
Topmount: Carefully align the sink over the
countertop opening and lower into position,
applying pressure to secure a seal of the silicone
against the countertop.
Undermount: Carefully align the sink under the
countertop opening and raise into position,
applying pressure to secure a seal of the silicone
against the countertop.
Re-check that the sink is evenly aligned with the
countertop.
Attach and tighten the clip brackets against
the edge of the sink. Do not tighten one screw
completely before others. Partially tighten one clip
then the one across from it, and so on until all clips
are fully tightened. This will safeguard against an
uneven or insecure installation.
Use a cloth with denatured alcohol along the
perimeter of the sink and countertop to remove any
excess sealant.
STAINLESS STEEL
TOPMOUNT CLIP
(MX Series)
Undermount Techniques and Clip Style
STAINLESS STEEL
TOPMOUNT CLIP
(US Series)
Topmount Clip Style Sampling
/