MicroNet SP390 Series User manual

Brand: MicroNet

Model: SP390 Series

Type: User manual

Quick Installation Guide

Power over Ethernet Adapter

Model No.:SP390-5/SP390-9/SP390-12

http://www.micronet.info

Introduction

Micronet Power over Ethernet (POE) adapter SP390 Series

(SP390-5, SP390-9, and SP390-12) is a revolutionary technology

for powering Ethernet terminals such as IP Telephone sets, wireless

access point, and Internet camera. The technology incorporates

electrical power onto a LAN data line enabling the delivery of

operating power in addition to datacom to Ethernet terminals over

standard cabling infrastructure.

Package Contents

Before you start installing the device, verify the following items are in

the package:

y PoE Injector

y PoE Splitter

y Power Cord

y Quick Installation Guide

Features

y Convey the power to your LAN equipment through Ethernet

cable

y Compliant with Micronet access point, IP phone and internet

camera

y Injector voltage: Input 100 to 240V AC

y Splitter voltage: DC output 5, 9, 12V depends on various model

number

y Short-circuit protection-keeping the Ethernet device fully

protected against any circuit shortage caused by wrong pin

assignment or cable damage

y Power LED indication

Physical Description

Installation

Connect to End

Device’s DC Jack

Connect to End

Device’s RJ-45

CAT-5 Cable, 100

meters maximum.

Connect to Switch/Hub

(Data input)

Connect to

AC Power

(100-240V)

WARNING:

Connect the Injector with Splitter only. Connecting the Injector

directly to other devices may cause serious damage!

End Devices

Injector

Splitter

Specifications

Model SP390-5 SP390-9 SP390-12

Injector Voltage

Input 100V to 240V AC, output 48V DC (Max.

0.35A)

Splitter Voltage

(Input)

DC input up to 48V from 36V (voltage drop)

Splitter Voltage

(Output)

5V- 2.4A 9V - 1.3A 12V - 1A

Power Jack

Diameter

2.1mm (Inside diameter)

5.5mm (Outside diameter)

Emission FCC, CE

Operating

Temperature

0°C~60°C

Operating

Humidity

5°%~90%

CE Mark Warning

This equipment complies with the requirements relating to

electromagnetic compatibility, the essential protection requirement

of Council Directive 89/336/EEC on the approximation of the laws of

the Member States relating to electromagnetic compatibility.

Company has an on-going policy of upgrading its products and it

may be possible that information in this document is not up-to-date.

Please check with your local distributors for the latest information.

No part of this document can be copied or reproduced in any form

without written consent from the company.

Trademarks:

All trade names and trademarks are the properties of their

respective companies.

P/N: 2300-0158

MicroNet SP390 Series User manual

MicroNet SP390 Series User manual

MicroNet SP390 Series User manual

Related papers

Other documents