1
Installation Instructions for
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Insert the glass panels through the bottom of the fixture, then secure them in place using the clips.
Install the cover to the bottom of the fixture and secure it in place using the cover screws.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
1
2
3
4
5
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.0
OL14370-OL14371
OL14370, OL14371
Outdoor
1A
JUNCTION BOX
MOUNTING
PLATE
3
4
FIXTURE
SCREW
6
7
8
9
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for wet locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
Randhurst Outdoor Wall
5
FIXTURE
LAMP
GLASS PANEL
CLIP
FIXTURE
6
COVER
COVER SCREW
7
8
9
Page is loading ...
Page is loading ...
SAVE THESE INSTRUCTIONS!
4
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.Feiss.com
© 2018 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
/
