1
Installation Instructions for
Harrow 1 Light Wall
1.2
WB1713
WB1713
Install the glass panels by sliding them into the fixture and securing them using the tabs.
Secure the mounting plate to the electrical box with the two mounting plate screws.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
1
2
3
1A
LAMP
4
HOT WIRE
BLACK WIRE
ELECTRICAL BOX
MOUNTING
PLATE
NEUTRAL WIRE
WHITE WIRE
2
2
5
6
FIXTURE SCREW
6
Wall
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is safety listed fo damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SOCKET
ALLEN WRENCH
MOUNTING
PLATE SCREW
7
7
GLASS PANEL
1
GLASS PANEL
TAB
Generation Lighting WB1718ORB Installation guide
Generation Lighting F2957/4DWO/ORB Installation guide
Generation Lighting VS47003-PN Installation guide
Generation Lighting VS20104HTBZ Installation guide
Generation Lighting VS48001-DPZ Installation guide
Generation Lighting WB1717PN Installation guide
Generation Lighting WB1732BS Installation guide
Generation Lighting VS20203 Installation guide
Generation Lighting OL14370 Operating instructions