Page is loading ...
16 cOA55_19449
CLASSIC ACCESSORIES, INC.
KENT, WA USA 98032 ©
2013
classicaccessories.com
CLASSIC ACCESSORIES, LLC
2264
0 68th AVENUE SOUTH
KENT
, WA 98032, USA ©
2016
cl
assicaccessories.com
18-093-010401-00, 18-094-010401-00, 18-095-010401-00, 18-097-010401-00, 18-098-010401-00,
18-099-010401-00, 18-100-010401-00, 18-012-010401-00, 78627, 18-147-010401-RT,
18-160-010401-RT
WARNING
Make sure your field of view is not obscured after mounting your
windshield to your UTV roll cage.
CAUTION
Be sure your windshield is strapped securely and tightly to your
UTV roll cage.
WARNING
Do not transport an installed windshield on an open trailer or
truck. The windshield could get damaged, could damage the UTV
and/or possibly come off in traffic possibly causing injury and/or
damage to other property.
WARNING
Warranty void if installed windshield is transported on an open
trailer or truck.
Installation
1. Place your windshield over the front of your roll cage with the QuadGear
logo on your windshield facing out and right side up. Loosely attach your
windshield to your roll cage first with the top straps and then with the side
straps (Fig. 1).
If your cover has additional straps along the top, secure them around the
horizontal bar.
NOTE: On most models the underside of the roll cage top is lined with a
rip-and-grip panel (front side only) that can be used to combine with the UTV
windshield (Fig. 2).
If your windshield has a rip-and-grip strip along the bottom edge, remove
the backing and centering the windshield, press firmly to your UTV. Allow 24
hours for the adhesive strip to cure.
2. Adjust the top straps and then the bottom straps to position your
windshield in the center of the roll cage uprights (Fig. 3). When it is centered
and level, tighten all the straps.
Cleaning
Don’t clean the clear plastic of your windshield when it is dry—you can
scratch it. The best way to clean the clear plastic is to hose it with water and
rub it with your bare hands or soft cloth. Liquid soap may be used.
Clean the fabric areas of your rear window with a soft brush and warm
water. DO NOT USE SOAP as it can damage the protective coatings on the
fabric. Air dry.
Storage
To avoid mildew be sure that your windshield is completely dry before you
store it for an extended period in an enclosed area.
do not
use soap
ne pas utiliser
de savon
no usar
jabón
do not
pack wet
ne pas
ranger
mouillé
no guardar
húmedo
not
waterproof
non
imperméable
no es
impermeable
no tools
required
aucun outil
nécessaire
no requiere
herramientas
no bleach
ne pas
javelliser
no usar
lejía
line dry
étendre
mouillé
colgar para
secar
do not iron
ne pas
repasser
no
planchar
INSTRUCTIONS: UTV WINDSHIELD
Fig. 1
Fig. 2
Fig. 3
Page is loading ...
Page is loading ...
/
