2. FSR
  3. TBRT-DSPT-BK

FSR TBRT-DSPT-BK, TBRT-MiniDS-BK, TBRT-USBA-BK Installation guide

  • Hello! I've reviewed the installation instructions for the FSR TBRT-SERIES Cable Retractor. This document provides a step-by-step guide on assembling, mounting, and securing the cable retractor using various components like brackets, pins, and screws. I'm ready to assist you with any questions you may have about the installation process or the features of this device.
  • What is the purpose of the ring pins?
    Where is the adjustable hanger nut located?
    What is the purpose of the #6 pan head screw?
FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43070 LIT1517
1a. ASSEMBLE RETRACTORS & GAP-FILLER BRACKETS
AS REQUIRED ONTO T6 GATHER BRACKET.
RETRACTOR T6 GATHER BRACKET
#6 FLATHEAD SCREW
#6 PANHEAD SCREW
GAP-FILLER BRACKET
(2) #6 FLATHEAD SCREW
4a. ALIGN RING-PIN HOLES AND INSERT (2) RING PIN ON
BOTH SIDES OF ASSEMBLY. FOR ADDITIONAL
TAMPER-PROOF INSTALLATION, INSTALL (2) #6-32 x 1/4
LONG PAN HEAD SCREW.
(2) RING PIN
BOTH SIDES
CLEVIS PIN
SECURE CLEVIS
PIN WITH HAIR-PIN
COTTER
4b. CENTER ADJUSTABLE HANGER AND LOOSEN
WINGNUT. ALIGN ADJUSTABLE HANGER HOLES
WITH RETRACTOR FLANGE HOLES, ENSURING THE
HANGER IS VERTICAL AS POSSIBLE, AND INSERT
APPROPRIATE-LENGTH CLEVIS PIN. SECURE
CLEVIS PIN WITH HAIR-PIN COTTER.
ADJUSTABLE HANGER NUT
LOCATED ON OPPOSITE SIDE
OF WINGNUT
(2) #6 PAN HEAD SCREW FOR
TAMPER-PROOF INSTALLATION
BOTH SIDES
4c. LIFT RETRACTOR ASSEMBLY TO TAKE UP ALL
SLACK AND TIGHTEN HANGER WINGNUT TO
ENSURE ASSEMBLY WEIGHT IS CARRIED BY THE
TABLE. HANGER NUT CAN BE TIGHTENED FOR
ADDITIONAL INSTALLATION SECURITY.
TBRT-SERIES CABLE RETRACTOR INSTALLATION INSTRUCTIONS
1b. FOR 3 OR FEWER RETRACTORS, INSTALL CHASSIS
SUPPORT BRACKET ONTO RETRACTOR.
CHASSIS
SUPPORT
BRACKET
(2) #6 FLATHEAD
SCREW
2. INSTALL ADJUSTABLE HANGER ONTO T6 SHROUD WITH
4" CLEVIS PIN AND SECURE WITH HAIR-PIN COTTER.
TABLE
T6 SHROUD
T6 ASSEMBLY
ADJUSTABLE HANGER
4" CLEVIS PIN
SECURE 4" CLEVIS PIN
WITH HAIR-PIN COTTER
NOTE WINGNUT
LOCATION
3. SLIDE RETRACTOR ASSEMBLY UP INTO T6 ASSEMBLY.
RING-PIN HOLE
RING-PIN HOLE
RETRACTOR ASSEMBLY
/