SWF EMBROIDERY MACHINE
fixing screws
T-wrench or L-wrench(2,4MM)
Set the lifting slider
and replace the shaft
1.Lightly Tighten the Base Plate Fixing Screws
1) Check the position of screws inside of sequin
device. [Refer to Picture 1-1]
How to Set the Lifting Guide Shaft
1
2
Lightly tighten the base plate
[Picture 1-2]
fixing screws. [Refer to Picture 1-2]
2) Use T or L wrench (4mm) to lightly loosen the base plate
[Picture 1-1]
[F3] SEQUIN DEVICE
A. Content
SU-M-26
Order Tools Required
B. Order
C. Details
JIG /
Instruments
No.
CD CODE No:
─ Ver.2009 1st ────────────────────── SunStar Co., Ltd ─
SWF EMBROIDERY MACHINE
move the lifting slider to adjust its looseness with
the lifting guide. [Refer to Picture 2-1]
A. Replace the Lifting Guide
① Use T or L wrench (2mm) to remove the lifting shaft
guide screws from the lifting base.
② Remove and replace the lifting guide shaft.
B. Assembly
① Assemble the lifting guide with the lifting slide.
② Tighten the base plate screws.
[Picture2-1]
2. Set the Lifting Slider and
1) While the base plate fixing screw is lightly tightened,
Replace the Shaft
[Refer to Picture 2-2]
[Picture2-3]
[Picture2-2]
[ Reference ]
[A] [B]
Caution ) Improperly inserted lifting slider or bent or
broken lifting guide shaft may cause noise during the
sequin work.
Caution ) When you insert the lifting guide shaft into
the lifting base after replacing it, 'A', end of the shaft,
should point to the floor.
A
B
Lifting Base
Lifting Shaft Guide
Fixing Screw
Lifting guide shaft
─ Ver.2009 1st ────────────────────── SunStar Co., Ltd ─
/
