The following instructions will allow you to
connect your LongView Wireless extender.
Should you require assistance, please
consult your installer/user guide.
To connect a LongView Wireless extender
Powering up the transmitter and computer
Connect your transmitter to an AC power source with one
of the included power supplies and power up your computer.
NOTE: Use only an Avocent-supplied power supply. The
transmitter must be powered up before the computer.
Connecting the peripherals to the receiver
Connect the extended user’s keyboard, monitor and
mouse into the appropriately marked ports on the rear of
the receiver.
Connecting the audio to the receiver
Connect your PC speakers into the receiver’s audio
output connection.
Connecting the peripherals to the transmitter
Power down the computer that will be part of your LongView
Wireless system and unplug its peripherals. Place the
transmitter near the computer and connect the LongView
Wireless transmitter cables into the computer’s PS/2
keyboard, PS/2 mouse and monitor connections.
Connecting the audio to the transmitter
Using the supplied audio cable, connect one end to the
transmitter’s audio input connection and the other end to
the computer’s audio output connection.
Connecting a local user to the transmitter
Connect the local user’s keyboard, monitor and mouse into
the appropriately marked ports on the rear of the transmitter.
Powering up the receiver
Connect your receiver to an AC power source with one of the
included power supplies and power up your computer.
Once you power up the receiver, a screen will display the
message Searching for CLT-XXX, OSD Closed, Waiting on
Video. Within a few seconds, the screen will go blank. A
new screen will display with your desktop image.
For additional information
For further instructions on LongView Wireless extender
connection, please refer to the installer/user guide
included with the extender to activate the OSD (On-
Screen Display) and run the Auto Setup feature.
Quick Installation Guide
LongView
®
Wireless Extender
Connect the
transmitter cable into
the appropriate ports
on the computer.
Connect the audio.
Connect to an
AC power source.
Connect to an
AC power source.
Connect the local
user’s keyboard,
monitor and mouse.
Connect the extended
user’s keyboard,
monitor and mouse.
To Contact Avocent Technical Support CALL (888) 793-8763 EMAIL [email protected] DOWNLOAD www.avocent.com
Avocent, the Avocent logo, The Power of Being There and LongView are registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. ©2004 Avocent Corporation. All rights reserved.
590-385-001B
Transmitter Receiver
7
4
Connect the
extended speaker.
6
5
Quick Installation Guide
LongView
®
Wireless Extender
Notifications and Approvals
To Contact Avocent Technical Support CALL (888) 793-8763 EMAIL [email protected] DOWNLOAD www.avocent.com
Avocent, the Avocent logo, The Power of Being There and LongView are registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. ©2004 Avocent Corporation. All rights reserved.
590-385-001B
USA Notification This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference and (2) this device must accept any interference received, including received interference that may
cause undesired operation.
Agency Approvals
UL, cUL, FCC
-
1
-
2
Avocent LV IP DH Quick Installation Manual
- Type
- Quick Installation Manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Avocent LongView Wireless Installer User manual
-
-
-
-
-
-
-
-
-