Midmark LED Dental Light Installation guide

Type
Installation guide
English-1
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
TP200 Rev. A
Applies to Models:
153637 (-001)
Language of origin: English
Note
Midmark recommends two installers when performing this procedure.
003-2450-00 Rev. B (5/29/13)
LED Retrot Kit (Ceiling Mount)
Installation [002-1534-00]
Step 1: Turn off electrical power to light.
Step 2: Remove Halogen Light.
A) Loosen set screw to slide collar up as shown.
B) Push fixed arm up to access key.
C) Remove key thru suspension tube hole.
Step 3: Disconnect wires.
A) Lower Halogen light arms.
B) Disconnect wire harness.
Collar
Fixed Arm
Key
Wire
Harness
Suspension
Tube Hole
Set Screw
Style A
midmark.com
English-2
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
TP200 Rev. A
Step 6: Turn on electrical power to light.
Step 5: Installation of LED Light.
A) Push fixed arm groove to line up with suspension tube hole.
B) Insert key thru suspension tube hole.
C) Loosen set screw to slide collar down.
D) Tighten set screw to secure light.
Step 4: Connect wires.
A) Connect wires harness.
B) Insert fixed arm into suspension tube.
Note: Use jumper wire provided when fix arm light
and suspension tube harnesses do not match.
Collar
Fixed Arm
Key
Wire
Harness
Fix Arm
Groove
Suspension
Tube Hole
Set Screw
Jumper
Harness
Suspension
Tube
Harness
Fix
Arm
Harness
Style A
midmark.com
  • Page 1 1
  • Page 2 2

Midmark LED Dental Light Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI