2. Industrial & lab equipment
  3. Electrical equipment & supplies
  4. Power conditioning
  5. Electrical relays
  6. Acroprint
  7. Relay Box

Acroprint Relay Box Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Acroprint Relay Box Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Acroprint
®
Relay Kit Instructions
06-0211-000 Rev. D
Specifications:
Input Voltage:
Input Current:
AC Output:
Relay Circuit:
Operating Temp:
Humidity:
Dimensions:
120vAC/240vAC 50/60 Hz
2 Amps Maximum
120vAC/240vAC 50/60 Hz
5A at 250vAC or 30vDC
0 to 50 ºC
0 to 90% RH Non-condensing
8.75 x 6 x 2
WARNING:
Your installation must meet all National and Local electric codes. A licensed
electrician should perform installation.
Votre installation doit répondre à tous les codes électriques nationaux et locaux.
Un électricien qualifié doit effectuer l'installation.
AVERTISSEMENT:
Notes:
1) Existing External Card Readers can be connected to CON4
2) See reverse side for graphical depiction of electrical connections
The Signal and Access Relay Box is designed for use with Acroprints badge reading terminals. it has two
independent types of switching circuits: a switched AC power line circuit and a mechanical relay circuit.
Either circuit may be used to control AC powered bells, alarms, horns, or door access electric strikes.
DC and all low voltage powered devices MUST use the mechanical relay contacts (an external power source
is required).
For mechanical dry contact relay switching us CON2:
-- Connect the device to the CON2 terminal strip using NO and COM connection points.
Wires should be stripped 1/4 inch.
-- If you are using the badge terminals Bell signal, slide the SW1 switch to side marked BELL.
-- If you are using the badge terminals Access signal, slide the SW1 switch to side marked ACCESS.
For direct AC power line switched circuits use CON1:
-- Direct switching means that the input voltage on CON5 is directly switched to CON1
-- Connect the device to the CON1 terminal strip using AC OUT, NEUT and GND
-- If you are using the badge terminals Bell signal, slide the SW2 switch to side marked BELL.
-- If you are using the badge terminals Access signal, slide the SW2 switch to side marked ACCESS.
CON1
CON 2
CON 3
CON 4
CON 5
NC
COM
NO
K1
LINE
NEU
GND
BELL
ACCESS
ACCESS
BELL
F1 2 AMP 250V
DELAY
F2 5 AMP 250V
12:00
GND
NEU
AC
OUT
DC
Power
Supply
Door
External
Slot
Reader
Horn
Electric
Strike
3/4
3/8
SW1 Relay
SW1 AC Out
/