Dale Tiffany TA101231 Operating instructions

Type
Operating instructions

Dale Tiffany TA101231 is a delicate lamp with a classic, simple design. It has a spring-clip socket that can accommodate maximum 15 WATT Type C7 Candelabra Bulb (bulb included). This easy-to-assemble lamp comes with detailed instructions to ensure a quick and damage-free setup. It is recommended to retain the original packaging for possible future return shipping purposes.

Dale Tiffany TA101231 is a delicate lamp with a classic, simple design. It has a spring-clip socket that can accommodate maximum 15 WATT Type C7 Candelabra Bulb (bulb included). This easy-to-assemble lamp comes with detailed instructions to ensure a quick and damage-free setup. It is recommended to retain the original packaging for possible future return shipping purposes.

Frog
C7 Bulb
Socket
Spring Tab
ASSEMBLY INSTRUCTIONS:
Item No.: TA101231
WARNING: All wires are connected. When unpacking, be careful not to pull wires as a bad
connection may result. Do not connect electricity until fixture is fully assembled. Unpack and place
all parts on a soft surface.
1. Install the bulb into the bulb socket.
2. Squeeze the spring tabs on the socket and place the socket
through the center hole on the bottom of the frog.
The spring clips will engage the socket in place
after assembly.
CAUTION: Turn the power off (unplug from the
wall outlet) before replacing the bulb. Make sure
the bulb has had sufficient time to cool down.
Do not subject to the lamp to any shock while
lit as shattering of the lamp may result.
Uses (1) maximum 15WATT Type C7 Candelabra Bulb
(Bulb included).
Cleaning of your lamp: To Clean, use a soft cloth only.
DO NOT use any chemicals or abrasive cleaners.
*SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE./
Made in China Revision -12/18/12
FOR RETURN SHIPPING PURPOSES:
PLEASE RETAIN ORIGINAL PACKAGING
TO MINIMIZE DAMAGE.
Frog
C7 Bulb
Socket
Spring Tab
INSTRUCIONES DE ASAMBLEA:
Modelo: TA101231
ADVERTENCIA
: Todos los cables están conectados. Durante el desembalaje, tenga cuidado de no tirar de los
cables como un mal conexión puede ocasionar. No conecte la electricidad hasta el aparato esté completamente
montada. Desembale y coloque todas las piezas en una superficie suave.
1 Instale la bombilla en el portalámparas.
2 Apriete las pestañas resorte en la toma de corriente y
coloque el enchufe a través del orificio central de la parte
inferior de la rana. Los clips de resorte hará que el zócolo
en lugar después del montaje.
PRECAUCIÓN
: Desconecte la alimentación
(desenchufar de la toma de pared) antes de cambiar
la bombilla. Asegúrese de la bombilla ha tenido
tiempo suficiente para enfriarse. No someta a la lámpara
a golpes mientras iluminado como destrozando
de la lámpara puede resultar.
Usos (1) Tipo máximo 15Watt C7 bombilla Candelabro
(Bombilla incluida).
Limpieza de lampara
Desenchufe la lámpara, limpiar con un trapo húmedo. No utilice los abrasivos.
*Guardar estas instructiones para una referencia futura.
Hecho en China Revision –12/18/12
PARA RAZONES DE REGRASAR: POR FAVOR
CONSERVE EL IMPAQUETADO ORIGINAL
PARA REDUCIR DAÑOS MINIMO.
Rana
Bulbo
zócolo
resorte
pestaña
  • Page 1 1
  • Page 2 2

Dale Tiffany TA101231 Operating instructions

Type
Operating instructions

Dale Tiffany TA101231 is a delicate lamp with a classic, simple design. It has a spring-clip socket that can accommodate maximum 15 WATT Type C7 Candelabra Bulb (bulb included). This easy-to-assemble lamp comes with detailed instructions to ensure a quick and damage-free setup. It is recommended to retain the original packaging for possible future return shipping purposes.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI