ASSEMBLY INSTRUCTIONS:
Item No.: TA101214
WARNING: All wires are connected. When unpacking, be careful not to pull wires as a bad
connection may result. Do not connect electricity until fixture is fully assembled. Unpack and place
all parts on a soft surface.
1. Install the bulb into the bulb socket.
2. Squeeze the spring tabs(A) on the socket (B) and place the socket
through the center hole on the bottom of the cross.
The spring clips will engage the socket in place
after assembly.
CAUTION: Turn the power off (unplug from the
wall outlet) before replacing the bulb. Make sure
the bulb has had sufficient time to cool down.
Do not subject to the lamp to any shock while
lit as shattering of the lamp may result.
Uses (2) maximum 5WATT Type C7 Candelabra Bulb
(Bulbs included).
Cleaning of your lamp: To Clean, use a soft cloth only.
DO NOT use any chemicals or abrasive cleaners.
*SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE./
Made in China Revision -01/09/13
FOR RETURN SHIPPING PURPOSES:
PLEASE RETAIN ORIGINAL PACKAGING
TO MINIMIZE DAMAGE.
Page is loading ...
/
