Hampton Bay HD-COUS-017 Installation guide

Type
Installation guide
HD-COUS-017
1001810432
206954986
207186373
MODEL#
SKU#
OMSID
(WHITE)
OMSID(MOCHA)
USE AND CARE GUIDE
25 IN. CUSTOM CLOSET ORGANIZER
THANK YOU
We appreciate the trust and confidence you have placed in Hampton Bay through the purchase of this closet organizer. We strive to continually
create quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs.
Thank you for choosing Hampton Bay!
Questions, problems, missing parts? Before returning to the store,
call Hampton Bay Customer Service
9 a.m. - 4 p.m. (Central Time), Monday-Friday
1 (855) 439-4663
HAMPTONBAY.COM
Or email us: [email protected]
2
Table of Contents
Safety Information
Please carefully read all precautions and instructions in this manual before you begin.
WARNING: This unit contains small parts which could be
a choking hazard for small children. Children should be
under adult supervision at all times or serious injury could
occur.
WARNING: Always unload the unit prior to moving it. The
weight of personal belongings can cause the unit to become
unstable and either tip or collapse. Serious bodily injury
and/or damage to personal belongings may occur.
WARNING: Do not climb or step on the unit. The unit may
become unstable and either tip or collapse. Serious bodily
injury and/or damage to personal belongings may occur.
WARNING: Follow the proper safety procedures when
using power tools and ladders.
WARNING: All units must be secured individually to the
wall stud using the L-bracket and wall screw provided. If
the wall stud is not accessible, consult your local hardware
store for the appropriate mounting hardware. Failure to do
so may create an unsafe tipping hazard that could lead to
serious bodily injury and/or damage to personal belongings.
WARNING: Do not overload the unit. If any shelf, top, or
bottom of the unit bows or bends more than
1
/2 in., it is
overloaded. The shelf, top, or bottom could collapse and
cause serious bodily injury and/or damage to personal
belongings.
2
Warranty
Table of Contents .......................................................... 2
Safety Information ......................................................... 2
Warranty ......................................................................... 2
One Year Limited Warranty ..................................................... 2
Pre-installation .............................................................. 3
Planning Installation ............................................................... 3
Tools Required ........................................................................ 3
Hardware Included ...................................................................3
Package Contents ....................................................................4
Installation ..................................................................... 5
Care and Cleaning ...................................................... 10
For more detailed information on the product warranty contact the Customer Service Team at 1 (855) 439-4663 or visit
www.Hamptonbay.com.
One Year Limited Warranty
3
Pre-installation
PLANNING INSTALLATION
Compare all parts in the packaging with the Hardware Included and Package Contents sections in this manual. If any part appears missing or
damaged, do not assemble this product. Contact the Customer Service Team.
This product has materials that contain finished and unfinished (raw wood) edges. During assembly, make sure to note in each diagram which
way the finished edges are facing. In general, all finished edges will face the direction most noticeable after assembly (up and out).
FINISHED EDGE
CORRECT INCORRECT
UNFINISHED “RAW” EDGE
ALWAYS ALIGN
FINISHED EDGES
TOOLS REQUIRED
Hammer
Phillips
screwdriver
Drill
HARDWARE INCLUDED
NOTE: Hardware not shown to actual size.
Part Description Quantity Part Description Quantity
A
A
Cam Post 24 II L-Bracket Wall Ancho
r
4
2gulP eloHJJ 42 kcoL maC BB
4 gulP eloH renroCKK 04 liaN CC
2lewoDLL 4 tuN mottoB DD
EE Leveling Feet 4 MM Pole Support Bracket (PSB) 6
FF L-Bracket 4 NN PSB Unit Mounting Screw 6
GG L-Bracket Long Screw 4 OO PSB Wall Mounting Screw 6
HH L-Bracket Short Screw 4 PP PSB Wall Ancho
r
6
AA
KK
FF GG HH II JJ
LL MM NN OO PP
CC DD EE
BB
HAMPTONBAY.COM
Please contact 1 (855) 439-4663 for further assistance.
4
Pre-installation (continued)
PACKAGE CONTENTS
A
A
A
A
C
C
B
B
B
B
D
D
D
D
D
D
D
D
Part Description Quantity
4troppuS ediS 4 A
4flehS mottoB/poT B
2flehS elddiM C
8troppuS renroC D
3 eloP E
E
E
E
5
Installation
BB
A
A
B
B
C
1
Attaching the cam posts to the
s
ide supports
Screw six cam posts (AA) into each of the two side
supports (A), as shown.
AA
A
A
2
Attaching the side supports to the
s
helves
With a side support (A) on each side of the top, bottom, and
center shelves (B and C) slide the attached cam posts (AA)
into the shelves (B and C).
Insert four cam locks (BB) into the four corners of each
shelf (B and C), as shown.
Turn the cam locks (BB) 1/4 turn clockwise to lock into
place.
Repeat these steps for the remaining shelves (B & C) and
side supports (A).
AA
BB
3
2
1
HAMPTONBAY.COM
Please contact 1 (855) 439-4663 for further assistance.
6
Installation (continued)
CC
DD
EE
D
D
D
D
A
A
B
B
C
3
Attaching the corner supports
Place corner supports (D) on each of the four corners of a
shelving unit, as shown.
Secure in place using five nails (CC) for each corner
support (D).
Repeat for the second shelving unit.
4
Attaching the leveling feet
Install bottom nuts (DD) and leveling feet (EE) into the
bottom of one of the shelving units. This is now the bottom
shelving unit.
7
Installation (continued)
FF
GG
HH
II
LL
5
Attaching the top shelving unit to
t
he bottom shelving unit
Insert a dowel (LL) into each side of the bottom shelving
unit.
Lower the top shelving unit gently into place on top of the
bottom shelving unit until it sits flush on top of the bottom
shelving unit.
6
Attaching the shelving units to the
w
all
For the bottom shelving unit, drill a hole for the wall
anchor (II) into the wall stud where the L-bracket (FF) will
be placed.
Install the L-bracket wall anchor (II) into the drilled hole.
Use the L-bracket long screw (GG) to secure the L-bracket
(FF) to the wall stud.
Use the L-bracket short screw (HH) to secure the L-bracket
(FF) to the side support (A).
Repeat these steps for the opposite side of the bottom
shelving unit.
Repeat all steps to attach the top shelving unit to the wall.
HAMPTONBAY.COM
Please contact 1 (855) 439-4663 for further assistance.
JJ
KK
8
Installation (continued)
MM
NN
7
Attaching the hole plugs
Place the corner hole plugs (KK) and hole plugs (JJ) into the
holes on the top of the top shelving unit.
8
Attaching the pole support
b
rackets to the shelving unit
Measure and mark 2 in. down from the top of the shelving
unit and 2 in. back from the front of the shelving unit.
Attach the pole support bracket (MM) over the
measurement mark using the two pole support bracket unit
mounting screws (NN).
Repeat these steps for the opposite side of the top shelving
unit and one side of the bottom shelving unit, as shown.
9
Installation (continued)
9
Attaching the pole support brackets to the wall
Measure and mark the placement for the pole support brackets (MM) on the wall. Make sure that it is even with the pole support
brackets (MM) on the shelving unit so that the poles (E) are level between the brackets.
Drill holes into the marked locations and insert wall anchors (PP) into the holes.
Secure the pole support brackets (MM) to the wall using wall mounting screws (OO).
MM OO
PP
WALL
WALL
HAMPTONBAY.COM
Please contact 1 (855) 439-4663 for further assistance.
MM
MM
E
E
10
Installation (continued)
10
Extending the closet pole to the
d
esired length
Grasp and pull a pole (E) apart until it is long enough to
reach from the shelving unit to the wall.
Repeat for each pole (E).
E
Care and Cleaning
To remove the part labels, gently rub a soft cloth moistened with a mild household cleanser over the part label. Then lift a corner of the
label and pullrmly but smoothly until the label comes off.
Dust as needed with a clean, lint-free absorbent cloth.
Spray furniture polish may be used when cleaning.
Scratches and nicks can be touched up with a furniture touch-up stick, shoe polish, or a crayon.
11
Attaching the poles to the
s
helving unit
Place one end of the pole (E) into the pole support bracket
(MM) on the shelving unit so that the hole in the pole (E)
end fits over the peg in the pole support bracket (MM).
Adjust the pole (E) as necessary to fit between the shelving
unit and the wall.
Place the other end of the pole (E) into the pole support
bracket (MM) on the wall.
Repeat these steps for the remaining poles (E).
Questions, problems, missing parts? Before returning to the store,
call Hampton Bay Customer Service
9 a.m. - 4 p.m. (Central Time), Monday-Friday
1 (855) 439-4663
HAMPTONBAY.COM
Or email us: [email protected]
Retain this manual for future use.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11

Hampton Bay HD-COUS-017 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI