Assembly Instruction
ITEM# D-BS210SCO
IMPORTANT:
Please read instructions thoroughly before assembly, get yourself familiar with the parts
list and assembly illustrations to ensure the safe and proper assembly.
Please keep the instructions for future reference.
WARNING:
Repeated assembly can weaken the locking ability of the washers. Please periodically
check all bolted connections on your bistro to ensure they are tight and secure.
DO NOT over tighten any screws or nuts.
DO NOT operate if any part is damaged or broken.
NOT FOR USE BY CHILDREN.
PARTS LIST:
Chair:
Tools Required: Adjustable Wrench (not included)
ASSEMBLY STEPS:
1. Attach the Foot Cap (D) (Pre-assembled) into the hole at the bottom of the Leg (C).
2. Attach the Bolt (E) (Pre-assembled) into the Seat back (A) and Seat Board (B).
3. Connect Seat Board (B) to Leg (C) using M8 Washer (E) and M8 Nuts (G). Tighten Nuts
(G) by using Wrench (P). (Fig.1)
4. Connect Seat back (A) to Seat (B) using M8 Washer (E) and M8 Nuts (G). Tighten Nuts (G)
by using Wrench (P). (Fig.2)
PARTS
QTY.
Image
A
Seat Back
1
B
Seat Board
1
C
Leg
4
D
Foot Cap (Preassemble)
4
E
M8 x 30 Bolt
10
F
M8 Washer
10
G
M8 Nuts
10
H
M8 Spring Washer
10
P
M8 Wrench
1
PARTS LIST:
Table:
ASSEMBLY STEPS:
1. Attach the Bolt (G) (Pre-assembled) into the Table top (A).
2. Connect Table Top (A) to Leg (B) using M8 Washer (E) and M8 Nuts (F). Tighten by using
Wrench (H). (Fig.1)
3. Connect Leg (B) to Joint Ring (C) using M8 x 25 Bolt (D), M8 Washer (E) and M8 Nut (F).
Tighten by using Wrench (H). (Fig.2)
Now your Rose 3pc Bistro Set is ready for use.
Limited Warranty:
This product carries a one (1) year warranty against defects in workmanship and materials.
Important: For technical assistance on assembly or replacement parts. In the continental U.S.,
you can call us toll-free at 1-866-578-6569 from 8 a.m. to 5 p.m. CST Monday – Friday. In the
continental Canada, you can call us toll-free at 1-844-SUNJOY1 (1-844-786-5691) from 8 a.m.
to 5 p.m. CST Monday – Friday. You can fax the replacement part form which is in the box to
(740)-283-3549 .You can also send us an email to customer[email protected].The
manufacturer reserves the right to repair or replace the defective product, at its discretion.
Made in China
PARTS
QTY.
Image
A
Table Top
1
B
Leg
3
C
Joint Ring
1
D
M8 x 25 Bolt
3
E
M8 Washer
9
F
M8 Nut
9
G
M8 x 30 Bolt
6
H
M6 & M8
Wrench
1
H
/
