Assembly Instructions
Item: L-DN1137SAL-F
IMPORTANT:
Please read instructions thoroughly before assembly. Familiarize yourself with the inventory of parts and the
accompanying illustrations to assure safe and proper assembly.
Repeated assembly can weaken the locking ability of the washers. Periodically check all bolted connections on
your product to make sure they are tight and secure. Please keep the instructions for future reference.
WARNING:
Read and follow all Warnings & Assembly Instructions before attempting to assemble.
Begin assembly not less than 6 feet from any obstruction such as a fence, garage, house, overhanging
branches, laundry line, or electrical wires.
Some parts may contain sharp edges.
Wear protective gloves as necessary.
Keep children away from assembly area.
Assemble on level ground.
Do not over tighten any of the bolts or nuts, but do tighten each bolt and nut until firm.
Check all nuts and bolts for tightness before and during usage.
MAINTENANCE:
1. Before using, clean the table completely with a soft dry towel.
2. Do not leave your table in wet conditions where there is a risk of rust developing.
3. When your bistro set is not being used, wipe free of any dirt or loose objects, wash with a mild solution of
soap and water; rinse thoroughly and dry completely. Do not use strong detergent or abrasive cleaners.
4. When not used, store in a cool, dry location away from sunlight.
LIMITED WARRANTY:
This limited warranty is extended to the original purchaser and applies to defects in materials and workmanship
of your item provided the item is maintained with care and used only for personal, residential purposes.
The item is warranted to be free from defects in material or workmanship for a period of one (1) year. If any
defect is found, please call our customer service department at 1-866-578-6569 for help. The manufacturer will
not cover transportation or delivery costs, or compensate the individual or any outside party for assembling or
disassembling the product. This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
SERVICE:
For technical assistance on assembly or replacement parts call Sunjoy Industries at 1(866) 578-6569 from 8:30
AM to 5:30 PM EST or Email customer.care@sunjoydirect.com
or visit www.sunjoydirect.com to place your
order or fax your parts replacement order form together with your purchase receipt to 1 (740) 283-3549 for
assistance.
Parts & Hardware List:
Assembly Instructions:
No.
Description
Qty
A Umbrella hole cap
1
B
Table top
1
C Leg
4
D Supporting frame
1
AA Bolt M8*40
8
BB Spring washer M8
8
CC Flat washer M8
8
DD Bolt M6*30
8
EE Spring washer M6
8
FF
Flat washer M6
(pre-assembled 24)
32
GG Bolt M6*20 (preassembled)
24
HH
Adjustable foot pad
(preassembled on C)
4
JJ Wrench M8
1
II Hex Key M6
1
Fig.1: Put the Slate Table Top (B) upside down on a soft, non-abrasive surface, connect the Leg (C) to the
Slate Table Top (B) with bolt (AA), spring washer (BB) and flat washer (CC). Please do not fully tighten the
bolts here.
Fig.2: Connect the Bottom Support Frame (D) to the Leg (C) with bolt (DD), spring washer (EE) and flat
washer (FF).Then fully tighten all the bolts. Turn over the whole assembled piece (suggest 2 persons), adjust
the foot pad as well.
Made in China
/
