ESAB Tradesarc DC180-1 is a welding current power source intended for use with coated electrodes (MMA welding). It is designed and tested in accordance with international and European standards IEC/EN 60974-1 and EN 50199 to be used by technicians with electrical/electronic training. The power module of the power source is a single forward converter, operating at a switching frequency of 65 kHz. IGBT transistors are used as the switching elements. All power semiconductors are built into modules. The duty cycle refers to the time as a percentage of a ten-minute period that you can weld at a certain load without overloading.
ESAB Tradesarc DC180-1 is a welding current power source intended for use with coated electrodes (MMA welding). It is designed and tested in accordance with international and European standards IEC/EN 60974-1 and EN 50199 to be used by technicians with electrical/electronic training. The power module of the power source is a single forward converter, operating at a switching frequency of 65 kHz. IGBT transistors are used as the switching elements. All power semiconductors are built into modules. The duty cycle refers to the time as a percentage of a ten-minute period that you can weld at a certain load without overloading.
ESAB Tradesarc DC180-1 is a welding current power source intended for use with coated electrodes (MMA welding). It is designed and tested in accordance with international and European standards IEC/EN 60974-1 and EN 50199 to be used by technicians with electrical/electronic training. The power module of the power source is a single forward converter, operating at a switching frequency of 65 kHz. IGBT transistors are used as the switching elements. All power semiconductors are built into modules. The duty cycle refers to the time as a percentage of a ten-minute period that you can weld at a certain load without overloading.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI