GE GPF610W Installation guide

GE
Brand
GE
Model
GPF610W
Type
Installation guide

This manual is also suitable for

GE Consumer & Industrial
Appliances
Installation Instructions
Dishwasher Door Panel Replacement Kits
for Long Door Front Mounted Control Models


TOOLS AND MATERIALS REQUIRED:
• Gloves to protect against sharp edges
• Phillips screwdriver
• 1/4" hex socket or 1/4" wrench
KIT CONTAINS:
• Door panel
• Instruction instructions
IMPORTANT – Save these instructions for local
inspector’s use.
IMPORTANT – Observe all governing codes and
ordinances.
Note to Installer – Be sure to leave these instructions with
the Consumer.
Note to Consumer – Keep these instructions with your
Owner’s Manual for future reference.
Stop Sign
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
WARNING:
To prevent electric shock, disconnect electrical power
supply to dishwasher before changing panels. Do not
operate dishwasher while changing panel.
CAUTION:
On new installations, do not remove wood base until
you are ready to install the dishwasher. The dishwasher
will tip over when the door is opened.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
GE Consumer & Industrial
General Electric Company
Louisville, Kentucky 40225
ge.com
Pub. No. 31-30563-1
DWG. NO. 206C1559P103
07K-2385 10/07
STEP 1–REMOVE DOOR PANEL
• Open dishwasher door.
• Remove the 6 Phillips head screws along the sides of the
door (see Figure 1) holding the inner door to the outer panel.
Retain screws, close door.
• Do not remove the 6 screws at the top of the door.
STEP 2–INSTALL THE ASSEMBLED PANEL
• Slide the panel assembly into the escutcheon slot (Figure 3).
• Reinstall the two original screws at the bottom of the door to
hold the assembly to the hinge arms (Figure 4).
• Open the dishwasher door and reinstall the original 6 Phillips
head screws to hold the inner door to the trim kit assembly
(Figure 5).
• Remove the two screws on the bottom of the door panel
(Figure 2). Allow door panel to slide down approximately 1/2".
Retain screws.
• Remove door panel.
Loosen 2 Screws
Escutcheon
Door
Panel
Bottom
Escutcheon
1/4 Hex Screws
DW Inst. 9
DW Inst. 10
Escutcheon
Escutcheon
Slot
DW Inst. 11
Figure 1
Figure 2
Loosen 2 Screws
Escutcheon
Door
Panel
Bottom
Escutcheon
1/4 Hex Screws
DW Inst. 9
Figure 3
Figure 5
Figure 4
DW Inst. 22
Do Not
Remov
e
Do Not
Remov
e
Do Not
Remov
e
  • Page 1 1
  • Page 2 2

GE GPF610W Installation guide

GE
Brand
GE
Model
GPF610W
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents