Renkforce GM-01 Owner's manual

Category
Coffee making accessories
Type
Owner's manual
Operating elements
The GoPro frame with its base and screws shown in the gures below are
not supplied.
1 Bracket
2 Long screw
3 Short screw
4 Microphone
5 HI/LO switch
6 Mini-B USB cable
3
4
5
6
2 1
Installation
Do not overtighten the screws, as this may cause damage to the product
and/or the GoPro frame.
a) Mounting the bracket to the GoPro frame
GoPro frame base
GoPro
frame
Screw of GoPro
frame base
GoPro frame with base
and screw (not supplied)
Remove the screw of the GoPro frame to separate the frame and its base.
Supplied long screw
Screw of GoPro frame
Bracket
Fit the GoPro frame, the bracket and the GoPro frame base together.
Secure with the supplied long screw and the screw of the GoPro frame.
b) Mounting the microphone and adjusting the distance between GoPro
and the microphone
Supplied short screw
Microphone
Put the microphone onto the bracket. Secure with the supplied short screw.
To adjust the distance between the microphone and the GoPro frame, unscrew the
short screw and relocate the microphone along the bracket. Then secure with the
short screw.
c) Setting up the microphone
Connect the mini-B USB cable to the mini-B USB socket of GoPro.
Optionally, cover the microphone capsules with the wind screen.
Set the HI/LO switch on the back of the microphone as desired when recording.
Operating instructions
GoPro Microphone
Item no. 1390555
Intended use
The product is intended to work with a GoPro camera. The microphone can catch
a wide range of background sound to be reproduced in good quality, making your
video impressive by enriching the background sound. Power is supplied by the GoPro
camera.
Contact with moisture, e.g. in bathrooms, must be avoided under all circumstances.
For safety and approval purposes (CE), you must not rebuild and/or modify this product.
If you use the product for purposes other than those described above, the product may
be damaged. In addition, improper use can cause hazards such as short circuiting,
re, electric shock etc. Read the instructions carefully and keep them. Make this
product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All
company names and product names are trademarks of their respective owners. All
rights reserved.
Delivery content
Microphone
Wind screen
Three-part bracket
Operating instructions
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
The device is not a toy. Keep it out of the reach of children and pets.
Do not leave packaging material lying around carelessly. These may
become dangerous playing material for children.
Do not place the product under any mechanical stress.
When setting up the product, make sure that the cable is not pinched,
kinked or damaged by sharp edges.
Protect the product from extreme temperatures, direct sunlight, strong
jolts, high humidity, moisture, ammable gases, vapours and solvents.
If it is no longer possible to operate the product safely, take it out of
operation and protect it from any accidental use. Safe operation can no
longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
Please handle the product carefully. Jolts, impacts or a fall even from a
low height can damage the product.
The complete product must not become wet or damp. Never touch the
product with wet hands.
Also observe the safety and operating instructions of any other devices
which are connected to the product.
Consult an expert when in doubt about operation, safety or connection of
the device.
Maintenance, modications and repairs are to be performed exclusively
by an expert or at a qualied shop.
If you have questions which remain unanswered by these operating
instructions, contact our technical support service or other technical
personnel.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE. V1_1115_02-ETS-Mkd
Maintenance and cleaning
This product does not require maintenance. There are no components located
inside the product that you need to maintain. Never open/dismantle the product.
Have maintenance and repairs done by qualied experts or repair shops only.
Unplug the mini-B USB cable from GoPro before cleaning.
To clean the product, a dry, soft and clean cloth is sucient. You can use a long-
haired, soft and clean brush and a vacuum cleaner to remove dust.
Never use any aggressive cleaning agents or chemical solutions as they may cause
damage to the housing or the product to malfunction.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the
relevant statutory regulations.
You thus fulll your statutory obligations and contribute to the protection
of the environment.
Technical data
Directivity .............................................Cardioid
Frequency response ...........................20 – 20000 Hz
Sensitivity .............................................HI: -34 dB ±4 dB
LO: -39 dB ±4 dB
Impedance ...........................................800 Ω ±30 %
Compatible with...................................GoPro Hero 3, 3 plus, 4
Power supply .......................................4 V/DC via mini-B USB
Operating conditions ..........................+5 to +45 ºC, 0 – 90 % RH
Storage conditions..............................-5 to +60 ºC, 0 – 90 % RH
Cable length .........................................15 cm
Dimensions (L × W × H) ......................52 × 97 × 49 mm (total)
52 × 32 × 26 mm (microphone)
Weight ...................................................36 g (total)
16 g (microphone)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Renkforce GM-01 Owner's manual

Category
Coffee making accessories
Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI