Davis Instruments 7705 Owner's manual

Brand
Davis Instruments
Model
7705
Type
Owner's manual

Davis Instruments 7705 Second Solar Panel is an accessory for the EZ-Solar Power Kit 7707. It doubles the light-gathering capability of the solar powered EZ-Mount system, making it suitable for use in far northern or southern latitudes with limited wintertime light, or other locations with limited solar exposure. The panel includes a solar panel and a regulator circuit. It connects to the EZ-Solar Power Kit using a 6-foot (1.8 m) power cable and Y-terminal adapters, which are included in the kit.

Davis Instruments 7705 Second Solar Panel is an accessory for the EZ-Solar Power Kit 7707. It doubles the light-gathering capability of the solar powered EZ-Mount system, making it suitable for use in far northern or southern latitudes with limited wintertime light, or other locations with limited solar exposure. The panel includes a solar panel and a regulator circuit. It connects to the EZ-Solar Power Kit using a 6-foot (1.8 m) power cable and Y-terminal adapters, which are included in the kit.

Product # 7705
S
ECOND
S
OLAR
P
ANEL
F
OR
EZ-S
OLAR
P
OWER
K
IT
This manual describes how to install and use the Second Solar Panel for the
EZ-Solar Power Kit. The second panel is for use in far northern or southern lat-
itudes, where wintertime light is limited, as well as other locations with lim-
ited solar exposure. This panel doubles the amount of light-gathering
capability of your solar powered EZ-Mount system. It includes a solar panel
and regulator circuit.
Note:
The Second Solar Panel is only for use with the EZ-Solar Power Kit 7707.
CAUTION:
Please note that while we have made every attempt to design and manufacture a safe product,
Davis Instruments cannot assume liability for any injury or damage caused directly or indirectly by the
installation or use of this product.
Components
The EZ-Solar Power Kit includes the following components. Please be sure
you have all listed components before beginning.
Solar Panel
Shelter
Power
Cable
Cap
Brace Clamp
Cable Ties
5/16"
Hex Nut
5/16" x 2"
Carriage Bolt
Arm
Y-Terminal
Adapters
Power
Connectors
Tools and Materials Needed
Page 2
Tools and Materials Needed
You may need the following for this installation:
✦
Adjustable Wrench or 5/16” Wrench
✦
Flat Head Screwdriver
✦
Pliers
✦
Wire Cutters or Scissors
Installation Guidelines
✦
The power cable supplied is six feet (6’, 1,8 m) long. Mount the Second
Panel close enough to your EZ-Solar Power shelter for the power cable
to reach without stressing the power cable connections.
✦
Refer to the EZ-Solar Power Kit manual for complete mounting
instructions.
Connecting the Cables
1. Open the EZ-Solar Power shelter
door using a flat head screw-
driver.
2. Disconnect the red/white wire
from the positive (+) battery ter-
minal.
3. Disconnect the black wires from
the negative (-) battery terminal.
4. Install the Y-terminal adapters on
the battery terminals. It is a tight
fit, so you might want to use pliers
to push the Y-terminal adapters onto the battery terminals.
5. Connect the red/white wires from the regulator to the Y-terminal adapter
on the positive (+) battery terminal.
6. Connect the black wires from the regu-
lator to the Y-terminal adapter on the
negative (-) battery terminal.
7. Remove one round vent plug from the
bottom of the EZ-Solar Power Panel.
8. Run the EZ-Solar Second Panel power
cable up through the power panel vent
hole.
9. Press the power cable’s vent plug into
the vent hole until it locks into place.
Y-terminal adapter installed on negative battery
terminal
Running the Second Solar Panel power cable
into the EZ-Solar Power shelter
Connecting the Cables
Page 3
10. Connect the red and white wires from the Second Solar Panel to the Y-ter-
minal adapter on the postive (+) battery terminal.
11. Connect the black wires from the Second Solar Panel to the Y-terminal
adapter on the negative (-) battery terminal.
12. To avoid wind damage, stuff any extraneous cable length back into the
field case and use the two cable ties provided to strap any exposed cables
to the extension tube (or tripod).
13. Close the EZ-Solar Power shelter door and secure the two mounting
screws using a flat-head screwdriver.
You have completed the installation.
Second Panel power cable connections to the Y-terminal adapters
Excess cable secured inside the EZ-Solar shelter, external cables tied to mounting pole.
Product Numbers: 7705
Davis Instruments Part Number: 7395.146
Second Solar Panel for EZ Solar Power Kit
Rev. A Manual (3/30/2001)
This product complies with the essential protection requirements of the EC EMC
Directive 89/336/EC.
© Davis Instruments Corp. 2001. All rights reserved.
3465 Diablo Avenue, Hayward, CA 94545-2778
510-732-9229 • Fax: 510-732-9188
E-mail: [email protected] • www.davisnet.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Davis Instruments 7705 Owner's manual

Brand
Davis Instruments
Model
7705
Type
Owner's manual

Davis Instruments 7705 Second Solar Panel is an accessory for the EZ-Solar Power Kit 7707. It doubles the light-gathering capability of the solar powered EZ-Mount system, making it suitable for use in far northern or southern latitudes with limited wintertime light, or other locations with limited solar exposure. The panel includes a solar panel and a regulator circuit. It connects to the EZ-Solar Power Kit using a 6-foot (1.8 m) power cable and Y-terminal adapters, which are included in the kit.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents