Grid Worksurface Tether Bracket Installation Instructions - UMTB
Rev 0715
UMTB PARTS KIT
QTY DESCRIPTION
1
4
4
4
1/Order
UMTB Base
UZSCREWW
UZWNUTA
SCREW1
TB INSTRUCTION
Bits Required:
Phillips
The easiest way to install these tether
brackets is by loosely installing the
UZSCREWW screw through the
tether bracket and attaching UZNUTA
nut so that the end of the screw is no
more then flush with the back of the
nut. Do this with all 4 screws as
shown in Figure A.
This will allow enough movement so
that you may install the UZNUTA's
into the two slots in the bottom rail of
the Grid frame. Do this by placing
the bottom 2 nuts in the bottom slot
first and slowly tilt the bracket while
arranging the top 2 nuts to slip into
the top slot.
Once all 4 nuts are in the slots,
screw the 4 screws into the nuts so
that you can still slide the bracket
along the bottom rail. Move the
bracket to desired location and with
the Phillips bit tighten the 4 screws.
Once all the brackets are located,
place worksurface with front legs
attached onto the tether brackets.
Locate top in desired location and
attach bracket to worksurface with
SCREW1 as shown in Figure B.
Figure A
Worksurface
Slots
Figure B Viewed
from Under Worksurface
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Friant & Associates Interra Installation guide
-
Eaton LMS Installation guide
-
Global Contract Bridges II Installation guide
-
-
-
-
-
Unbranded PDR7236SP-B/BK:OKPU Operating instructions
-
-
