Visual Comfort Studio BBL 5015SB-S Installation guide

Brand: Visual Comfort Studio

Model: BBL 5015SB-S

Type: Installation guide

Visual Comfort Studio BBL 5015SB-S is a customizable chandelier that provides ample lighting for various spaces. Its adjustable chain allows for tailored hanging lengths, accommodating different ceiling heights. The fixture features a sturdy backplate that securely mounts to the ceiling outlet box. The neutral and hot wires from the fixture are conveniently color-coded for effortless electrical connections. The chandelier's shade attaches easily to the stem, providing a stylish touch.

BBL 5015

ASSEMBLY & INSTALLATION GUIDE

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT

BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR

OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Determine the desired hanging length of chandelier. Adjust the length of chain (E) by using screwdriver to loose/

tighten screws at both top and bottom side of links. (See illustration below to open the link and connect to canopy

and ﬁxture loop and close the link)

2. Attach ground ﬁxture wire (silver or copper in color) to ground wire from wall outlet box (usually green or copper

in color), fasten together with a plastic wire connector. Tightly wrap the wire connector with electrical tape so the

end of the connector is sealed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY

GROUNDED.

3. Connect neutral (ridges molded) ﬁxture wire coming from ﬁxture base to neutral (usually white)

4. outlet wire. Fasten both wires together with a plastic wire connector and tightly wrap the wire connector with

electrical tape.

5. Repeat the procedure with the hot (smooth covering) wires. Always make sure that no wire strands are left

outside the connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE

COMPROMISED.

6. To detach back plate (A) from light ﬁxture by unscrewing base screws (D).

7. Position back plate (A) diagonally so that the holes of back plate (A) and ceiling outlet box are aligned. Tighten the

mounting plate onto the ceiling outlet with mounting screws (C).

8. Gently push the ﬁxture base (B) onto the afﬁxed back plate (A), and secure with base screws (D).

9. Attach shade (G) to stem (H), slide shade spider on threaded section under washer (F). And secure by turning washer

(F) in clockwise direction.

10. Screw rod (J) on bottom threaded nipple of part (H).

11. Insert light bulbs into sockets.

12. Remove ﬁnial (M) & washer (L) from rod (J), attach shade diffuser (K) over bottom threaded section of rod (J), and

secure with washer (L) & ﬁnial (M).

Visual Comfort Studio BBL 5015SB-S Installation guide

Visual Comfort Studio BBL 5015SB-S Installation guide

Visual Comfort Studio BBL 5015SB-S Installation guide

Related papers

Other documents