2. Visual Comfort Studio
  3. CHD 1552PN-FG

Visual Comfort Studio CHD 1552PN-FG Installation guide

  • Hello! I've reviewed the Assembly & Installation Guide for the CHD1552 lighting fixture. This guide provides detailed steps for safe installation, including grounding, wiring, and mounting the fixture and glass shade. I'm ready to answer any questions you have about the installation process or the device itself.
  • What should I do before installing the fixture?
    What should I do if I find damage or a defect on the fixture?
    What are the steps for connecting the fixture wires?
    How do I mount the fixture to the wall?
    What is the final step after inserting light bulbs?
CHD1552
ASSEMBLY & INSTALLATION GUIDE
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT
BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Attach ground (green) fixture wire to ground wire from junction box (usually green or copper in color), and fasten
together with a plastic wire connector. Tightly wrap the wire connector electrical tape so the end of the connector is
sealed.
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.
2. Connect neutral (white) fixture to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire
connector and tightly wrap the wire connector with electrical tape.
3. Repeat the procedure for hot (black) wires. Always make sure that no wire strands are left outside the connectors.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTION OR SAFETY WILL BE COMPROMISED.
4. Place fixture base (A) to wall outlet box and secure with mounting screws (B) provided.
5. Insert light bulbs into sockets.
6. Attach glass shade (D) to fixture base (A), aligning top and bottom holes of glass shade (D) and fixture base (A).
Tighten by inserting base screws (C) to the holes to secure glass shade to fixture base.
/