Perfect Lift Window Treatment QFCR220720 Installation guide

CORDLESS TOP-DOWN BOTTOM-UP

BLACKOUT SHADE

SAFETY INFORMATION

Please read and understand these instructions before attempting to assemble,

install, or operate this product.

INSTALLATION INSTRUCTIONS

Step 1: Check Package Contents

Before installing your shade, make sure all parts listed below are present. If any

part is missing or damaged, please do not assemble, install, or operate. To

request replacement parts, contact customer service at 1-844-318-6168, Monday

through Friday from 8:00 a.m. to 4:30 p.m. EST.

1

Contents include:

 TDBU Shade

 Mounting Hardware Kit

Mounting Hardware Kit includes:

Part Quantity

a. Mounting Brackets 2 (for 18” to 36” widths)

3 (for 37” to 48” widths)

4 (for 49” to 72: widths)

b. 1” Screws 2 per bracket

c. Handle for Middle Rail 1 (2 for shades over 59” wide)

d. Handle for Bottom Rail 1 (2 for shades over 59” wide)

Step 2: Gather Additional Tools Required

The following tools are not included, but will be needed to complete your

installation.

 Screwdriver

 Tape measure

 Pencil

 Drill

 Drill bits

 Step ladder

a

b

c

d

Head Rail

Middle Rail

Bottom Rail

2

TIP: For dry wall or plaster mounting, use #6 plastic anchors (not included).

TIP: For screws, use 3/32-inch drill bit; for wall anchors, use ¼-inch drill bit.

Step 3: Install the Mounting Brackets

Your shade may be installed either inside or outside the window frame. A

mounting bracket should be positioned about 1 to 6 inches from each end of the

head rail. Wider shades that require three or more brackets should be spaced

evenly between the two outermost brackets. Always position the brackets so

there is no interference with the cords and/or mechanisms inside the head rail.

The procedure outlined below will assure proper bracket placement.

To Attach the Brackets:

Place the locking arm facing out. Next, position the bracket so that it engages the

inner front and outer back of the head rail, and then push the locking arm inward

to lock it in place.

For Outside Mounting:

Clip the brackets onto the head rail as described above. Hold the shade level at

the height desired and center it over the window opening. Mark the exact location

of each bracket with a pencil. Remove the brackets from the head rail. Pre-drill

the screw holes using a 3/32” drill bit (not included). Position the top of each

bracket at the pre-drilled holes and screw each bracket into the wall or window

molding using the 1” screws.

For Inside Mounting:

Clip the brackets onto the head rail as described above. Hold the shade level in

place and make a pencil mark at the rear of each bracket where it contacts the

inside of the window frame. Remove the brackets from the head rail. Pre-drill the

screw holes using a 3/32” drill bit (not included). Align each bracket with the

holes and attach using the 1” screws.

Step 4. Attach the Handle(s)

Attach the handle to the bottom rail as illustrated below. The handle is designed

to minimize contact with the shade fabric. Always raise and lower the shade

SLOWLY to assure that the pleated fabric stacks neatly.

3

Wider shades have two handles. To precisely determine the correct position for

each handle, divide the total width of the shade by 4, and then attach one handle

that distance from each outside edge of the shade. Always grasp both handles

when lifting and lowering the shade.

Attach the second handle to the middle rail as illustrated.

Step 5. Properly Operate and Care For Your Shade

IMPORTANT: READ CAREFULLY

 Make sure the handles have been attached to the rails as described in

step four.

 To maintain optimal performance of the springs that make your cordless

shade function, lift and lower the shade through its full range of motion—

all the way up and down—every day if possible.

 For shades with single handle, which must be centered on the rails, lift or

lower the shade slowly and evenly, keeping the rails level, until the shade

is positioned as desired.

 For wider shades with a double set of handles, grasp the handles using

both hands and lift the shade slowly and evenly, making sure to keep the

rails level.

 To raise and lower the shade from the bottom, follow the directions above.

 To lower and raise the shade from the top, grip the middle rail handle(s)

and slowly pull straight down/up.

Trouble lifting your cordless shade?

 If the shade is left in one position for a long period of time, it might be

necessary to lift and lower the shade several times to restore normal

function.

 If the shade has been fully raised for a long period of time, it might tend to

spring back or rebound slightly from the desired length position. This can

also be remedied by lifting and lowering the shade several times.

CLEANING INSTRUCTIONS

Bottom Rail

Middle Rail

Head Rail

4

The vinyl head rail, middle rail, and bottom rail can be wiped clean with a damp

sponge. To clean the fabric, use a feather duster or vacuum lightly using a soft

brush attachment.

REPLACEMENT PARTS

If you require replacement parts, contact customer service at 1-844-318-6168,

Monday through Friday from 8:00 a.m. to 4:30 p.m. EST. Please be sure to

provide the following information, if possible:

• The complete model or item number of your product

• A description of the product

• A description of the part needed

ONE-YEAR LIMITED WARRANTY

For a period of one (1) year from the date of purchase, the manufacturer will

replace this window covering with one of equal or superior value, if this window

covering is found to be defective in material or workmanship. To obtain warranty

service, contact our customer service department at 1-844-318-6168. This

warranty does not cover damage of defects caused by or resulting from improper

maintenance, negligent or improper use, abuse, misuse, neglect, accidents, act

of God, alterat

ion, commercial use, installation, removal, or reinstallation.

This warranty is restricted to normal consumer use within the United States and

Canada. MANUFACTURER WILL NOT BE LIABLE FOR INCIDENTAL OR

CONSEQUENTIAL DAMAGES; SOME STATES DO NOT ALLOW THE

EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL

DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY

TO YOU. This warranty gives you specific legal rights, and you may also have

other rights, which vary from state to state.

QUESTIONS?

Contact customer service at 1-844-318-6168, Monday through Friday from 8:00

a.m. to 4:30 p.m. EST.

5

Printed in Taiwan

Page is loading ...

Perfect Lift Window Treatment QFCR220720 Installation guide

Perfect Lift Window Treatment QFCR220720 Installation guide

in other languages

Related papers

Other documents