Thank you for buying an Angelo Décor Fountain!
We hope you will find these instructions helpful in setting up your fountain.
If you have any issues with this item, please DO NOT return the unit to place of purchase.
Please visit our web site, www.angelodecor.com, for assistance and warranty information.
First unpack carton carefully, arranging parts safely in your working area.
Feed the pump cord through the cord hole and align with
the groove at the base as shown above. The pump should be set to full
strength.
Set the large cover plate into
place on top of the bowl by
The including tubing shown above
will be used with this fountain.
Connect the end with the shortest
piece of tubing to the pump. Feed the longest piece of tubing
up through the access hole to
Slide the "slip fit" pipe into this
same hole. Feed the tubing up
Now simply fill with clean water and plug into a grounded GFCI outlet
We recommend keeping bowl 3/4 full of water to avoid pump burnout.
Product must be
ro
erl
stored for winter.
.
Feed the remaining tube
up through the hole in
the plate as shown.
Set the second plate
on top of this bowl as
shown.
Set the final plate
into place.
Set the final bowl in place by
sliding it over the white pipe
and setting it on to the plate.
Connect the tubing to the top feature.
Set the top into place by sliding it over
the white pipe.
Install the pump
access door.
The final assembly should
look like this
Set the bowl in place by sliding it down over the
white pipe. Connect the tubing from the
previous step to the outlet on the bottom of this
bowl. Carefully set the bowl in place.
oduct ust be p ope y sto ed o te