2. ELK
  3. ELK-M1VO

ELK ELK-M1VO Operating instructions

  • Hello! I have analyzed the provided document regarding the ELK M1VO Voltage Output Conversion Board. It details how to connect the board for converting ribbon cable connections to screw terminals, and how to connect it to M1 controls or M1XOVR expanders. I'm ready to answer any questions you may have.
  • What is the first step in using the M1VO?
    How do I connect the M1VO to the M1 control?
    What should I do after making the connections?
PO Box 100 3266 US Hwy 70 West
Hildebran, NC 28637 Connelly Springs, NC 28612
Ph 828-397-4200 Fax 828-397-4415 hps://www.elkproducts.com
Printed in USA
5/24/18
J1
E LK -M1VO
POSITIVE VOLTAGE
OUTPUT S
7 8 9 10 11 12 13 14 15 1 6
NEG +12V
12 11 10 9 8 7 6 5 4 3 2 1
+12V
NEG
16
15
14
13
12
11
10
9
8
7
J16
J5
OUT3 LED
OUT3
OUTPUTS
N/CCOMN/O
Example wiring
voltage outputs to
two LEDs on an
LED Status Plate
+
-
+
-
LED
Status
Plate
ELK-M1VO
VOLTAGE OUTPUT CONVERSION BOARD
Converts 12 conductor ribbon cable connecons to screw terminal connecons.
• Compable with posive voltage outputs of M1 controls and M1XOVR output expanders
• Simplies connecons for quicker and neater installaons
• Mounts on self-adhesive feet
• Includes 6” ribbon cable
• Dimensions: 1”W x 3”H x .625”D
1. Power down the M1 control.
2. Use supplied 6” ribbon cable to connect the M1VO to the J16
connector of the M1 control or the J3 connector of the M1XOVR
3. Make desired connecons to the M1VO terminals
4. Power up the M1 Control.
Instrucons
NOTE: When using the ELK-M1VO with an ELK-M1XOVR output expander, terminals 7 & 8 of the M1VO are unused. The rst voltage output of the M1XOVR is connected to terminal 9.
/