Power Gear 94315 User guide

Brand: Power Gear

Model: 94315

Type: User guide

Power Gear 94315 is a portable power inverter that can convert 12V DC power from a vehicle battery to 110/120V AC power, making it possible to power various electronic devices and charge 110/120V AC devices designed for use in North America. With a continuous power output of 100W and a peak power of 200W, it can handle most laptops, tablets, mobile phones, portable gaming devices, cameras, and other small electronics. Additionally, it features a 1.0A USB charging port for convenient charging of USB-powered devices.

94315 Package Contents

• Power inverter

• User’s Manual

Features

• Fan-based cooling system

• Sliding safety outlet covers

• Blue LED power indicator

• 3 point pivoting head

• 100W continuous power

• 200W peak power

• 1.0A USB charging port

• Replaceable fuse

Safety Features

• Low battery protection

• Over temperature shutdown

• Short circuit shutdown

• Overload protection

IMPORTANT SAFETY INSTRUCTIONS

WARNING: RISK OF FIRE AND SHOCK

ALWAYS remove the inverter from the power

port when not in use. Do not leave this inverter

or any device operating unattended in the

vehicle.

NEVER replace fuses with a higher rating than

speciﬁed by the manufacturer.

DO NOT place any items on or over the inverter

during operation. Always use the inverter

where there is adequate ventilation.

AVOID placing the unit in direct sunlight or

near the vehicle’s heat vent.

DO NOT expose to extreme heat or ﬂames.

Use ONLY in dry locations. NEVER immerse the

unit in liquids such as water or use when wet.

DO NOT operate the inverter near ﬂammable

materials, fumes, or gases.

DO NOT insert foreign objects into the inverter’s

AC outlet , USB outlet or vents.

DO NOT open product case.

The inverter will NOT operate appliances and

equipment that produce heat, such as hair

dryers, microwave ovens and toasters.

Inverter is NOT recommended for use with

inductive loads such as ﬂuorescent lamps,

compressors & pumps.

DO NOT use the power inverter in a positive-

grounded vehicle. Especially for older vehicles,

check with your dealer or mechanic to ﬁnd

out if you have a positive-grounded vehicle.

The majority of modern vehicles, RVs and

trucks are negative ground.

DO NOT connect the inverter to household

or RV AC distribution wiring.

KEEP AWAY FROM CHILDREN!

The inverter is not a toy.

Operating Instructions

The inverter must be connected only to

batteries with a nominal output voltage of

12 volts. The unit will not operate from a 6 volt

battery and will be damaged if it is connected

to a 24 volt battery.

1. Plug inverter into you vehicle’s power

port. Adjust the inverter’s plug as needed

for better positioning.

Note: You can use an AC and USB device at

the same time, but the total power load can

not exceed 100W.

2. Slide safety covers to display desired outlet.

3. Plug in your device into the USB and/or

AC outlet.

Operating Tips

Operate the inverter only in the

following conditions:

DRY – Do not allow water or other liquids

to come into contact with the inverter.

COOL – Ambient air temperature should

be between 32°F and 77°F (0°C – 25°C). Keep

the inverter away from direct sunlight, if at

all possible.

VENTILATED – Keep the area surrounding the

inverter clear to ensure free air circulation

around the unit. Do not place items on or over

the inverter during operation. The unit will shut

down if the internal temperature gets too hot.

The unit will restart once it cools down.

SAFE – Do not use the inverter near ﬂammable

materials or in a location that may accumulate

ﬂammable fumes or gases.

Portable

Power Inverter

Thank you for purchasing the 94315 100W

Power Inverter. This device can be used to

power laptops, tablets, mobile phones,

portable gaming devices, cameras, and other

portable devices. It can also charge 110/120V

AC devices made for use in North America.

PLEASE READ ALL iNSTRUCTIONS BEORE USING

THIS POWER INVERTER.

Thank you for choosing Power Gear!

Please visit www.jascoproducts.com

for any additional information.

User’s Manual

USBAC

Safety Covers Pivoting

Head

Fuse

LED

Replacing the Fuse

If the fuse has blown, replace it with a

15A Mini Blade Automotive Fuse (not supplied)

1. Take the fuse removal tool and grasp

onto the fuse.

2. Pull fuse outward until removed from inverter.

3. Place new fuse into the appropriate

fuse location.

Caution:

DO NOT use a fuse with a different rating.

Doing so can damage your inverter.

MAKE SURE new fuse has been securely

placed in slot.

Troubleshooting

If a device doesn’t power up, or the

power indicator doesn’t light up, there are

several possible causes:

Vehicle battery voltage is lower than 10V

Run the vehicles engine to recharge

the battery.

Temperature exceeds 167°F (75°C)

Unplug the device and wait until

the inverter cools. Your devices power

requirement might also exceed the

inverter’s rating.

Continuous power load exceeds 100W

Disconnect the device. Ensure the total power

consumption of all devices connected to the

inverter does not exceed 100 watts.

Blown Fuse

See “Replacing the Fuse.”

For Product support, call 1-800-654-8483

Speciﬁcations

Output Wavefom: Modiﬁed Sine Wave

Output Power: 100W continuous power

DC Input: 13.8V DC 8A

Output Voltage: 115 VAC @ 13.8V DC

USB Output: 5V DC @ 1000 mA

Fuse: 15A Mini Blade Automotive

Dimensions (H x W x D) - 138 x 70 x 39mm

FCC Information

This device complies with the part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference. (2) This device

must accept any interference received, including interfer-

ence that may cause undesired operation

This equipment has been tested and found to comply with

the limits for a class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential instal-

lation. This equipment generates uses and can radiate radio

frequency energy, and if not installed and used in accor-

dance with the instructions, may cause harmful interference

to radio communication. However, there is no guarantee

that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to cor-

rect the interference by one or more following measures

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and the receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

• Consult the dealer or an experience radio/TV

technician for help.

Changes or modiﬁcation not expressly approved by Jasco

Products may cause interference and void the user’s author-

ity to operate the equipment.

90 Day Limited Warranty

Jasco Products warrants this product to be free from

manufacturing defects for a period of ninety days from the

original date of consumer purchase.

This warranty is limited to the repair or replacement of this

product only and does not extend to consequential or

incidental damage to other products that may be used with

this unit. This warranty is in lieu of all other warranties express

or implied. Some states do not allow limitations on how long

an implied warranty lasts or permit the exclusion or limitation

of incidental or consequential damages, so the above

limitations may not apply to you. This warranty gives you

speciﬁc rights, and you may also have other rights which vary

from state to state. Simply return to: Jasco Products

Company, 10 E Memorial Rd. Oklahoma City, OK 73114

Power Gear 94315 User guide

Brand: Power Gear

Model: 94315

Type: User guide

Download PDF

report

Power Gear 94315 User guide

Power Gear 94315 User guide

Other documents