User manual
6
CLEANING
1. Before using this appliance, please always clean it. After having using it, clean the inner part of the
appliance with a sponge and soapy cold water.
2. Do not use solvents, abrasive creams or tools that can scratch: the warming disc is covered with a
non-stick layer, which could avoid to get damaged.
3. When you wash it, be careful not to wet any electrical component.
4. Do not place the milk frothed into the dishwasher.
NOTE: The Milk Frother or any of its accessories are NOT dishwasher safe.
TROUBLESHOOTING
Issue Reason Solution
Indictor light doesn’t work /
Jug doesn’t work
Plug is not inserted properly Re-insert plug
Jug isn’t connected to power base
properly
Remove jug and replace correctly
No power in the jack Check the electric circuit
Jug doesn’t work after
operation
Jug temperature is too high Rise cold water inside the jug to
reduce temperature
Jug is damaged with immersion water
Repair or replace
Motor doesn’t work Jug not cleaned in good time after
use, milk locks the mechanism
Clean and move the shaft sleeve
of motor by hand to loosen it.
Charring Dosage of milk either too little or too
much
Ensure the milk is between min
and maxi level
Jug was reused without cleaning
/Rinsing
Always clean after each use.
Actual Voltage is much lower than
specified voltage
Ensure you use the appropriate
voltage