2. Anolis
  3. ArcSource Submersible II Submersible Fixture LED Light

Anolis ArcSource Submersible II Submersible Fixture LED Light User manual

  • Hello! I've reviewed the Installation Instructions for the ARCSOURCE SUBMERSIBLE II. This document details how to properly install the unit using bracket or floor stand mounting options for safe submersion up to 10 meters. I'm ready to answer any questions you might have about the installation process.
  • Who should install the fixture?
    What is the maximum depth for underwater installation?
    What are the two main mounting options?
INSTALLATION INSTRUCTIONS
ARCSOURCE SUBMERSIBLE II
ROBE lighting s. r. o. | Palackeho 416 | 757 01 Valasske Mezirici | Czech Republic | Tel.: +420 571 751 500 | E-mail: info@anolis.eu | www.anolislighting.com
VERSION 2.0 / 2_2023 1
QR code for Installations Instructions
INSTALLATION INSTRUCTIONS
ARCSOURCE SUBMERSIBLE II
ROBE lighting s. r. o. | Palackeho 416 | 757 01 Valasske Mezirici | Czech Republic | Tel.: +420 571 751 500 | E-mail: info@anolis.eu | www.anolislighting.com
VERSION 2.0 / 2_2023 2
STEP 1.A
INSTALLATION WITH STANDARD MOUNTING BRACKETS
1
Drill 2 holes to the surface according to brackets spacing.
Release locking screw on each sides. Angle xture to desired
position and tighten locking screw on each sides.
Fixture must be installed by a qualied electrican in accordance with all national and local electrical
and construction codes and regulations. This device falls under class one and must be grounded!
The unit is intended only for permanent underwater installation up to depth of 10 m.
2
INSTALLATION INSTRUCTIONS
ARCSOURCE SUBMERSIBLE II
ROBE lighting s. r. o. | Palackeho 416 | 757 01 Valasske Mezirici | Czech Republic | Tel.: +420 571 751 500 | E-mail: inf[email protected] | www.anolislighting.com
VERSION 2.0 / 2_2023 3
Release locking screw on each side. Angle xture to desired
position and tighten locking screw on each sides.
Drill 4 holes to the surface according to brackets spacing.
Attach oor stand to xture with supplied bolt, washer, and
cap nut.
1
STEP 1.B
INSTALLATION WITH FLOOR STAND
32
/