2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Anolis
  7. SubDrive 4
SubDrive 4

Anolis SubDrive 4 User manual

  • Hello! I've reviewed the installation instructions for the Anolis Subdrive 4. This document provides a step-by-step guide for qualified electricians, covering housing installation, wiring, cable gland usage, and ensuring a watertight seal. I'm ready to answer any questions you might have about the device and its installation.
  • Who should install the fixture?
    What class does this device fall under?
    What is the required wrench size for cable gland M20x1.5?
    What is the required wrench size for cable gland M12x1.5?
    What is crucial to avoid water leaks?
INSTALLATION INSTRUCTIONS
SUBDRIVE 4
ROBE lighting s. r. o. | Palackeho 416 | 757 01 Valasske Mezirici | Czech Republic | Tel.: +420 571 751 500 | E-mail: info@anolis.eu | www.anolislighting.com
VERSION 2.0 / 2_2023 1
QR code for Installations Instructions
INSTALLATION INSTRUCTIONS
SUBDRIVE 4
ROBE lighting s. r. o. | Palackeho 416 | 757 01 Valasske Mezirici | Czech Republic | Tel.: +420 571 751 500 | E-mail: info@anolis.eu | www.anolislighting.com
VERSION 2.0 / 2_2023 2
Fixture must be installed by a qualied electrican in accordance with all national and local electrical
and construction codes and regulations. This device falls under class one and must be grounded!
STEP 1
OPEN BOX
Drill holes to the surface according to holes spacing. Mount
SubDrive via mounting holes to the surface.
Uncover SubDrive.
Connection – colour coding
STEP 2
INSTALL HOUSING
Power Connection - Power IN
L N GROUND
Core (EU) Brown Blue Green/Yellow
Core (US) Black White Green
DMX CONNECTION
0V D- D+
Data Ground Data - Data +
Cable CE/US Leader - LED Output
WIRE DATA AND POWER
CONNECTION
Red +
Orange Data
Blue -
2
STEP 3
CONNECTION
POWER IN
A
Power Connection 7mm
Strip these lenghts for cable connections
LED OUTPUT
and DMX
A
Power Connection 5mm
Data Connection 5mm
1
INSTALLATION INSTRUCTIONS
SUBDRIVE 4
ROBE lighting s. r. o. | Palackeho 416 | 757 01 Valasske Mezirici | Czech Republic | Tel.: +420 571 751 500 | E-mail: inf[email protected] | www.anolislighting.com
VERSION 2.0 / 2_2023 3
Wiring connection
STEP 4
CABLE GLAND INSTALLATION
For Data and Power - EU color code shown
Use wrench size 24 for cable gland M20x1.5
Use wrench size 16 for cable gland M12x1.5
Install Cable glands individually!
STEP 5
CLOSE BOX
Failure to properly install cable glands will result in fai-
lure of the water tight seal! Before applying the torque, make sure the thread is clean and
functional.
Install top cover making sure the gasket is in good condition
and is positioned properly in the groove.
3
/