N
L
1of4
LightSourceToolsRequired
BULB BASE TYPE
Medium (E26)
BULB SHAPE
TYPE A
100W
MAX
5BULBSREQUIRED
BULBSNOTINCLUDED
Warnings and Cautions
Turn off the electricity at the circuit breaker
before installation. Consult a licensed
electrician if in doubt about installation.
Turn off power to the fixture and allow the
bulbs to cool before replacing.
Crossbar Assembly
x1
A
Package Contents
PARTS BAG
Fixture Body
x1
I
Crossbar
Assembly
Rods&Small Loop Quick Link Ceiling Canopy
Table of
Contents
STEP 1 STEP 2 STEP 3 STEP 6
FixtureHeightAdjustable
17”to53”
ECeiling Canopy
x1
Quick Link
x2
D
Preparation: Identify and inspect all parts
before beginning the installation.
Missing or damaged parts? Contact your
original place of purchase.
Wiring
STEP 5
6”L Rod
x4
G
12”L Rod
x4
H
Small Loop
x2
F
Bulb
STEP 7
Lanyard
STEP 4
Outlet Box Screw
x2
B
Wire Connector
x3
C
Installation Instructions: UQL3130
www.urbanambiance.com
2of4
STEP 2 1 2 3
Step 1
Install crossbar assembly
Step2-3
Test fitting ceiling canopy to nipple
STEP 1
Optional Rods
8’ ceiling:
9’ ceiling:
10’ ceiling:
(2) 6”L + (2) 12”L rods
(2) 6”L + (4) 12”L rods
(4) 6”L + (4) 12”L rods
1 2
N
L
STEP 3
N
L
N
L
N
L
www.urbanambiance.com
N
L
3of4
STEP 4 1
2
Step 1
Feed the fixture wires
through the ceiling canopy
N
L
Step 2
Install Lanyard
STEP 5
*Green Ground Screw
on crossbar optional
White wire (neutral)
from outlet box
Ground wire
from Fixture
Black or Red wire (hot)
from outlet box
Bare or Green ground wire
from outlet box
Supply wire from fixture
Ribbed side or identified
with the Label “N”
supply wire from fixture
Smooth side or identified
with the label “L”
www.urbanambiance.com
4of4
STEP 6
STEP 7
www.urbanambiance.com
/
