1of4
LightSourceToolsRequired
BULB BASE TYPE
Medium (E26)
BULB SHAPE
TYPE A
100W
MAX
5BULBSREQUIRED
BULBSNOTINCLUDED
Warnings and Cautions
Turn off the electricity at the circuit breaker
before installation. Consult a licensed
electrician if in doubt about installation.
Turn off power to the fixture and allow the
bulbs to cool before replacing.
Crossbar Assembly
x1
A
Package Contents
PARTS BAG
Fixture Body
x1
Crossbar
Assembly
Rods
Ceiling Canopy
Table of
Contents
STEP 2 STEP 3 STEP 4
STEP 7
FixtureHeightAdjustable
14.25”to50”
ECeiling Canopy
x1
Preparation: Identify and inspect all parts
before beginning the installation.
Missing or damaged parts? Contact your
original place of purchase.
Wiring
STEP 6
6”L Rod
x4
G
12”L Rod
x4
H
F
Bulb
STEP 8
Lanyard
STEP 5
Outlet Box Screw
x2
B
Wire Connector
x3
C
Ceiling Canopy
Frame
x2
I
Stem
x2
J
Lock Screw
x8
K
STEP 1
Fixture Body
Installation Instructions: UQL3122
www.urbanambiance.com
2of4
STEP 3 1 2 3
Step 1
Install crossbar assembly
Step2-3
Test fitting ceiling canopy to nipple
STEP 2
Optional Rods
8’ ceiling:
9’ ceiling:
10’ ceiling:
(2) 6”L + (2) 12”L rods
(2) 6”L + (4) 12”L rods
(4) 6”L + (4) 12”L rods
For angled ceilings,
Swivel opening towards wall.
90 Degree Swivel
STEP 1
www.urbanambiance.com
3of4
STEP 5
STEP 6
*Green Ground Screw on
crossbar optional
White wire (neutral)
from outlet box White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
Black or Red wire (hot)
from outlet box
Bare or Green ground wire
from outlet box
STEP 4
Unlock hex nuts inside of the ceiling
canopy to separate swivels from the
ceiling canopy.
www.urbanambiance.com
4of4
STEP 7
STEP 8
www.urbanambiance.com
/
