HELVAR LC-SRA Click-on strain relief Installation guide

Hello! I've reviewed the Installation Guide for the LC-SRA Strain Relief. This document provides instructions on how to install the strain relief, including connecting wires, locking parts, and securing cables. I'm ready to answer any questions you have about this product and its installation process.
How to lock the bottom part to the driver?

What should I do when connecting wires?

What to avoid when connecting wires for Active+ drivers?

How to lock wires?

What is recommended to use to lock wires?

Helvar | Data is subject to change without notice. I28 008 1 B 8.5.2019

LC-SRA

Strain Relief Installation Guide

1. Lock the bottom part to the driver so that it clicks into place.

2. Connect wires into correct terminals according to driver datasheet instructions.

NOTE for Active+ drivers

Ensure that the connector is properly inserted

and pushed firmly into place.

Avoid tension to the connector,

no pushing or pulling force.

Option 1.

Sensor / Control unit cable in the same slot with load cable Option 2.

Load cable separately in the center slot

(if load cable diameter > 4,8 mm)

Continues on the next page

3. Lock wires with the cable clamps.

Ensure that cables are tightly locked.

It’s recommended to use tool

to push the clamp

Check connections once more

after locking the clamps!

Helvar | Data is subject to change without notice. I28 008 1 B 8.5.2019

Ø 3 - 10 mm

Ø 4,8 - 12,5 mm

4. Lock the cover on the bottom part.

Pay attention that

the cover clicks

into place properly!

LC-SRA

Strain Relief Installation Guide