2. HELVAR
  3. LC-SRB Click-on strain relief

HELVAR LC-SRB Click-on strain relief Installation guide

  • I've reviewed the Helvar LC-SRB Strain Relief Installation Guide and I'm ready to assist with any questions you may have. This document provides step-by-step instructions on how to install the strain relief, including how to properly connect wires, use cable clamps, and ensure secure locking of all parts.
  • What should you do after locking the clamps?
    What should be avoided when connecting the wires?
    What should be paid attention to when locking the cover?
Helvar | Data is subject to change without notice. I28 006 1 A 4.4.2019
LC-SRB
Strain Relief Installation Guide
1. Lock the bottom part to the driver so that it clicks into place.
2. Connect wires into correct terminals according to driver datasheet instructions.
NOTE for Active+ drivers
Ensure that the connector is properly inserted
and pushed firmly into place.
Avoid tension to the connector,
no pushing or pulling force.
Option 1.
Sensor / Control unit cable in the same slot with load cable Option 2.
Load cable separately in the center slot
(if load cable diameter > 4,8 mm)
Continues on the next page
3. Lock wires with the cable clamps.
Ensure that cables are tightly locked.
It’s recommended to use tool
to push the clamp
Check connections once more
after locking the clamps!
Helvar | Data is subject to change without notice. I28 006 1 A 4.4.2019
Strain Relief Installation Guide
Ø 3 - 10 mm
Ø 4,8 - 12,5 mm
Ø 4,8 - 12,5 mm
4. Lock the cover on the bottom part.
Pay attention that
the cover clicks
into place properly!
/