2. TMI Products
  3. Camaro Molded Sport Door Panel

TMI Products Camaro Molded Sport Door Panel Installation guide

  • Hello! I am an AI chatbot trained to assist you with the TMI Products Camaro Molded Sport Door Panel Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Sport Door Panel Instrucons
Step 1:
Begin by removing your original stock door panel,
and wipe the under-laying surface clean
with rubbing alcohol.
1968-69-CAMARO-MOLDED-SPORT-DOOR PANELS
Be sure to wipe thoroughly with
cleaning substance.
Figure 1.
Figure 2.
Step 2:
Take your drill hole template, cut template
in half so you have DRV side & PAS side.
Make sure template ts ush with inner door
structuer and mark your drill holes
for your Pull Handle Cup Bracket before
you drill, to determine best place tment.
TABLE OF CONTENTS
TOOLS NEEDED FOR INSTALL:
1. Shop Rag 4. Drill
2. Screws 5. Scissors
3. Phillips Screwdriver
I. Remove Stock Door Panel...........................................................................................................................1
II. Locate Pre-Exisng Holes...........................................................................................................................1
III. Pull-Handle Cup Bracket Installaon.........................................................................................................2
IV. Install Door Panel.....................................................................................................................................3
V. Reinstall Window Crank, Door Handle, & Pull Handle Cup.........................................................................3
*NOTE*: Fits STANDARD interior doors ONLY. Must install door handles to work with DELUXE interiors.
Part #99-8300-000
QP 09-272 REV. 01
Step 4:
Aer you are nished drilling in your bracket,
your door frame should look identical to the
picture in gure 4.
Step 5:
Use scissors or a razorblade
to cut slits in door panel for your window crank,
and door handle.
Step 3:
Locate your pre-cut holes,
and begin drilling your holes
for your bracket.
Figure 3.
Figure 5.
Figure 4.
*NOTE*: Fits STANDARD interior doors ONLY. Must install door handles to work with DELUXE interiors.
Part #99-8300-000
QP 09-272 REV. 01
Figure 6.
Figure 7.
Step 6:
Proceed to place and t your new
Sport Panel starting from the top,
then slide down until Panel clicks into place.
Step 7:
Make sure your panel is aligned,
and ts correctly from top to bottom.
Double check your alignment,
when door panel ts ush,
Drill three self tapping screws
upwards from the bottom of panel to
door frame.
Step 8:
Proceed to re-install your Pull-Handle Cup,
Window Crank, and Door Handle.
is now completes your Sport door panel
installation.
Enjoy your new TMI Sport Door Panels!
Figure 8.
*NOTE*: Fits STANDARD interior doors ONLY. Must install door handles to work with DELUXE interiors.
3 Screws here
Part #99-8300-000
QP 09-272 REV. 01
/