Sport Door Panel Instrucons
Tools Needed:
1.Adhesion Promoter 4.Phillips Screwdriver 7.Rag
2.Rubbing Alcohol 5.Self Tapping Screws 8.Plasc Trim Tool
3.Double Sided Tape 6.1/8 inch Drill Bit
Step 1.
If you are installing the Standard
equiped door panel,refer to step 1.b.
However, if you have a Deluxe Style Door
Panel, now begin to remove stock door panel.
Step 1.b
Using the Drill Hole Template supplied on Page
4, poke holes through the indicated holes pointed
out by the arrows. Now hold Drill HoleTemplate
against the door panel directly over the holes
depicted in Figure 11. With a marker, mark two
dots where you previously poked through the Drill
Hole Template. Now proceed to drill a 1/8th inch
hole on each marked dot.
1. 2.
3.
4.
5. 6.
7.
8.
MUSTANG-SPORT-DOOR PANELS
Be Sure to wipe thoroughly with
cleaning substance
Rubbing
Alcohol
Figure 1.
Figure 2.
Table Of Contents