GetFace IP
Surface installation - Wedge Backplate - 2 modules (must be together with ZVP-CB2M)
ZVPWBPLA2 Assembly instructions
© Zennio Avance y Tecnología S.L. Ed. 1 Further information www.zennio.com Page 1 / 2
WEDGE BACKPLATE ASSEMBLY
1 Please verify that the wall where the backplate will be
installed is smooth. If not, apply adhesive cement or a similar
construction material in order to adapt the irregularities of the
wall.
2 Drill the wall. The drill pattern can be used to make the
holes – in such case, please pay attention to the path of the
cables. Insert the expandable plugs.
3 Fix the basic module to the backplate by means of the
screws supplied with the first one.
4 Place and fix the Surface Frame ZVP-CB2M with the Allen
key.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
