2. Legrand
  3. 880

Legrand 880, Walkerbox Brass Floor Box Covers - 895GFI, 895TGFI Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Legrand 880 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Walkerbox
®
Brass Floor Box Covers
Cat. Nos. 895GFI and 895TGFI
INSTALLATION INSTRUCTIONS
Walker
®
electrical systems conform
to and should be properly grounded
in compliance with requirements of
the current National Electrical Code or
codes administered by local authorities.
All electrical products may represent a
possible shock or fire hazard if improperly
installed or used. Walker electrical prod-
ucts may bear the mark as UL Listed
and/or Classified and should be installed
in conformance with current local and/or
the National Electrical Code.
1. Locate the outlet box and remove the top protector cap.
2. Pull necessary wires, following the National Electrical Code and/or
local codes.
3. If using a box with adjusting
screws, adjust the floor plate
to the proper height.
4. Apply a bead of acrylic latex
around the box, sealing the
opening between the floor
box and the adjacent concrete.
5. Install a listed wiring device
(not supplied by Walker).
6. Install fill-in plate. Tear out
perforated area of gasket and
place gasket around receptacle.
7. Attach the floor cover
(895GFI or 895TGFI),
using the brass screws
provided. Fasten securely.
8. Close and latch the flip lid when receptacle is not is use.
Carpet or Tile Trim to Fit Inner
Edge of Floor Plate Ring
Walker Systems, Inc.
1000 Innovation Drive, Williamstown, WV 26187
IAO150 1099© Copyright 1999 The Wiremold Company All Rights Reserved
/