2. Razor
  3. Power A2

Razor Power A2 User manual

  • Hello! I've reviewed the provided user manual for the Razor Kickstand A2 W13110002028 replacement. The document outlines the necessary steps and safety precautions for replacing the kickstand, requiring a 3mm Allen wrench. I am ready to answer your questions about this procedure and the device described in the document.
  • What tool is required for kickstand replacement?
    What is the first step in the kickstand replacement procedure?
    What should I do before conducting any assembly or maintenance?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciļ¬c Time.
1
WARNING
Step 1 Step 2
Required Tool: (Not included)
A. 3 mm Allen wrench
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a 3 mm Allen wrench, loosen and remove the two
(2) bolts that hold the kickstand onto the frame. Remove
kickstand.
Reverse the steps.
ATTENTION: Charge battery 8 hours before using.
POWER A2
KICKSTAND REPLACEMENT PROCEDURES
PART # W13110002028
/