1
25
8
7
6
6
3
4
3
4
A SHORT WALK THROUGH DANTE NDI BRIDGE
Choose your Network Adaptor (your Dante Network).
Activate or Deactivate the BirdDog Comms Pro compatibility.
Dante to NDI
If No. of Audio Channels is set on “6 Channels”, you need to choose an NDI Output
Name for your Dante to NDI.
If No. of Audio Channels is set on “Stereo Pair”, you need to choose all 3 NDI Output
Names for your Dante to NDI.
NDI to Dante
You need to select which NDI Source you prefer to use.
Once the above settings are complete you can activate Dante with the toggle.
Allow the software to load.
Once running you can turn ON/OFF Dante to NDI or NDI to Dante
(these functions are only active once Dante is turned on as per instruction )
NOTE:
To modify the NDI Output Name or the NDI source, you need to turn OFF the Dante
main toggle ( )
To access the free Dante Controller just press the CONFIGURE button on the top-right
side. ( ). Dante Controller is required to be running somewhere on the network.
You can now add a Dante Name.
1
2
5
6
8
3
4
5
5
7
Click the main logo
to go to settings
COMMS Compatibility
inactive
Turn Dante ON
to control this switch
Turn Dante ON
to control this switch
Turn Dante OFF
to control this section
COMMS Compatibility
active
Activate/Deactivate
Dante
Type your personal
NDI Output name
Select your
NDI source
Select the number
of Audio Channels
between Stereo Pair
and 6 Channels
Select the desired
Network
Select the number
of Audio Channels
between Stereo Pair
and 6 Channels
Activate/Deactivate
NDI to Dante
IMPORTANT NOTES:
Ensure Internet connection
Install NDI Tools
click here
Install Dante Controller
click here
Help & Support
help@BirdDog.tv
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
GRASS VALLEY T2 4K Series Digital Recorder/Players User manual
-
RGBlink PTZ NDI Camera User manual
-
-
Netgear M4250 User guide
-
-
-
-
-
-