Fusion CP-AW1120 User manual

ACTIVE WEDGE

SPECIFICATIONS

 CP-AW1120 CP-AW2120

PeakPower(Watts) 750 900

RatedPower(Watts) 250 300

FrequencyResponse 32Hz-250Hz 32Hz-250Hz

LowPassFilter(Variable) 40Hz-250Hz 40Hz-250Hz

Tuning BassReex BassReex

WooferSize 12” Dual12”

Fuse 25A 30A

Dimensions(mm) 567(l)x415(w)x384(h) 836(l)x415(w)x384(h)

 22-5/16x16-11/32x15-3/32” 32-29/32x16-11/32x15-3/32”

CP-AW1120, CP-AW2120

www.fusionelectronics.com

CONTROL DESCRIPTIONS

LEVEL

Thisallowstheadjustmentoftheamplierlevelofthesubwoofer.

Turnclockwisetoincreasethelevel.Ifthesoundbecomesdistorted

reducethelevel.

LOW PASS FILTER (LPF)

This allows the adjustment of the highest frequency the Active

Wedgewillproduce.Thisshouldbeadjustedtoblendwithyourmain

speakers.Typically,thiswillbesettoaround100Hz(approximately

thecentralpositionofthecontrolknob).

REMOTE LEVEL CONTROLLER

Whenconnected,thisallowsfurthercontroloverthelevelfroma

remotelocation,usingthesuppliedlead.

INSTALLATION

MakesuretheActiveWedgeisrmlyxedinyourvehicle.Check

beforedrillingorcuttingholes.DONOTworkneargastanks,fuel

lines,hydrauliclinesorelectricalwiring.

DO NOT mount the Active Wedge in such a way as to pinch or

damagethewires.

Make sure everything is rmly connected, before attaching the

+12Vwire.Ensurethe+12Vwireisfusedascloseaspossibletothe

battery.Alwaysuseafusewiththerecommendedrating.

DISCLAIMER

AlwaysensuretheActiveWedgeissecurelyattached,toavoidmovement.FUSIONacceptsnoresponsibilityfordamageorinjuryinrelation

toinappropriatesecuringofthisproduct.

WIRING

• Connectthegroundwiretothevehiclerst(cleandirtandpaint

 tobaremetal).

• Connecttheremoteon(bluewire).

• ConnecttheRCAcablesifapplicable,OR

• Connectthespeakerlevelwirebysplicingintotheheadunits 

 speakerwires.SeeNote1onreverse.

• Connecttheremotelevelcontrollerwiththesuppliedlead.

• Connectthe12volt(redwire)tothepositivebatteryterminal.

• Checkallconnections.

PUBLISHEDBYFUSIONELECTRONICSLIMITED:©Copyright2010byFUSIONElectronicsLimited.Allrightsreserved.Specicationsanddesignaresubjecttochangewithoutnotice.

YOUCANHELPPROTECTTHEENVIRONMENT!Pleaseremembertorespectthelocalregulations:Handinthenon-workingelectricalequipmenttoanappropriatewastedisposalcenter.

RECORD YOUR PURCHASE DETAILS HERE:

SERIALNUMBER

DATEOFPURCHASE

AFFIXRECEIPTHERE

WARNING:AudioSystemscanproducesoundlevelsover135dB.Continuousexposuretosoundpressurelevelsover100dBmaycausepermanent

hearingloss!Pleasewatchforemergencyvehiclesaswarningsignalsmaynotbeheard.USECOMMONSENSE!