Fusion CA-AM41200 User manual

Category
Car audio amplifiers
Type
User manual

This manual is also suitable for

AMPLIFIERS
AMPLIFIER SPECIFICATIONS
CA-AM10900 CA-AM20350 CA-AM20650 CA-AM40700 CA-AM41200
PeakPower(Watts) 900 350 650 700 1200
FrequencyResponse 15Hz-185Hz 10Hz-100kHz 10Hz-100kHz 10Hz-100kHz 10Hz-100kHz
Dimensions(mm) 267(l)x230(w)x49(h) 267(l)x230(w)x49(h) 377(l)x230(w)x49(h) 377(l)x230(w)x49(h) 457(l)x230(w)x49(h)
10-1/2x9-1/16x1-15/16” 10-1/2x9-1/16x1-15/16 14-27/32x9-1/16x1-15/16 14-27/32x9-1/16x1-15/1618x9-1/16x1-15/16”
PowerRatings 300WRMSx1 55WRMSx2 115WRMSx2 50WRMSx4 110WRMSx4
@4Ω1%THD+N, @4Ω1%THD+N, @4Ω1%THD+N, @4Ω1%THD+N, @4Ω1%THD+N,
480WRMSx1 85WRMSx2 170WRMSx2 80WRMSx4 150WRMSx4
@2Ω1%THD+N @2Ω1%THD+N, @1%THD+N, @2Ω1%THD+N, @2Ω1%THD+N,
175WRMSx1 340WRMSx1 160WRMSx2 300WRMSx2
@4ΩBridged @4ΩBridged @4ΩBridged @4ΩBridged
1%THD+N 1%THD+N 1%THD+N 1%THD+N
CA-AM10900 CA-AM20350 CA-AM20650 CA-AM40700 CA-AM41200
www.fusionelectronics.com
INSTALLATION GUIDELINES
1. Ensurethe+12Vleadisdisconnectedfromthebatterybeforeyouconnectanynewequipment.
2. Ensurethemountinglocationwillnotinterferewiththegastank,brakelinesorelectricalwiring.
3. EnsuretheAmplierissecurelyfastenedtothevehicletopreventdamageintheeventofanaccident.
4. Ensureallwiringisprotectedtoavoidpinchingorcrushingwhichcouldresultindamagetotheaudiosystem.
5. Ensurethemountinglocationhassufcientairowaroundtheamplier.Iftheamplierismountedinanenclosedspacea
3”fanwithductingshouldbeusedtoaidinairow.
6. Donotmountanyamplieronasubwooferenclosureasextendedexposuretovibrationmaycausemalfunctionoftheamplier.
7. Ensureyouusetherecommendedgaugewire/cableforallamplierconnections.
WIRING
Ensuretheaudiosystemisturnedoffbeforemakinganyconnections
totheamplier,speakersorsourceunit.
Failuretodo so could resultin permanent damage tothe audio
system.WhenwiringtheFUSIONamplierensurethatthecable
isprotectedfromsharpobjectsandalwaysuserubbergrommets
whenwiringthroughmetalpanels.
Ensure all terminals and connections are protected from the
vehiclechassisandfromeachotherasfailuretodosocouldresult
inpermanentdamagetotheaudiosystem.
POWER
FUSIONampliersshouldbeconnecteddirectlytothe+12Vbattery
terminalwithaninlinefuseorcircuitbreakerasclosetothebattery
aspossible.
GROUND
Whengrounding/earthingyouramplier ensurethatthelocation
isa good sourceofground(preferablythe oorpan). Makesure
themetaliscleanofpaintetcasapoorearthcoulddamageyour
audiosystem.
REMOTE TURN ON
Thisconnectionturnstheamplieronandshouldbeconnectedto
theremoteturnonwirefromtheHeadUnit.Ifoneisnotavailable
aswitched12vsourcemustbeused.Eitherapowerantennawire
orACC+12V.
LOW LEVEL INPUTS
ChoosethecorrectlengthRCAinterconnectsandrunthemtothe
RCAoutputsofthesource/headunit,avoidingrunningbesideother
loomsandorpowercable.
LEVEL CONTROL
Thiscontrolisusedtomatchtheinputleveloftheampliertothe
outputlevelofyouheadunit.Werecommendthefollowingmethod.
1. Turntheamplierleveltozero
2. Turnthevolumeoftheheadunitto¾andthebassandtreble
tozero
3. Adjustthelevelcontroluntilthedesiredmaximumvolumeis
achievedwithoutdistortion.
4. Failuretofollowthesestepsmaycausepermanentdamageto
theaudiosystem.
PUBLISHEDBYFUSIONELECTRONICSLIMITED:©Copyright2010byFUSIONElectronicsLimited.Allrightsreserved.Specicationsanddesignaresubjecttochangewithoutnotice.
YOUCANHELPPROTECTTHEENVIRONMENT!Pleaseremembertorespectthelocalregulations:Handinthenon-workingelectricalequipmenttoanappropriatewastedisposalcenter.
RECORD YOUR PURCHASE DETAILS HERE:
SERIALNUMBER
DATEOFPURCHASE
AFFIXRECEIPTHERE
WARNING:AudioSystemscanproducesoundlevelsover135dB.Continuousexposuretosoundpressurelevelsover100dBmaycausepermanent
hearingloss!Pleasewatchforemergencyvehiclesaswarningsignalsmaynotbeheard.USECOMMONSENSE!
RECOMMENDED AMPLIFIER INSTALLATION KITS
FUSIONrecommendsthefollowingAmplierInstallationKittobe
usedwithourAmpliers
CA-AM10900 AC-AK04E 4GaugeInstallationKit
CA-AM20350 AC-AK08E 8GaugeInstallationKit
CA-AM20650 AC-AK04E 4GaugeInstallationKit
CA-AM40700 AC-AK04E 4GaugeInstallationKit
CA-AM41200 AC-AK04E 4GaugeInstallationKit
TROUBLE SHOOTING
Problem Possible Reason Solution
Ampliernotswitchingon. •No+12Vtopowerwire •Checkfusesandconnectionstobattery
PowerLEDnot‘on’. •Nopowertoremotewire •Checkremoteonconnectionstoheadunit
•Fusebroken •Replacefusewithcorrecttypeandamperage
Ampliernotworking, •Fuseonamplierblown •Replacefusewithcorrecttypeandamperage
butPowerLEDis‘on’ •Ampliertoohot •Moveampliertoventedarea
•Turnheadunitdown
•Speakerwiresshorted •Checkthattherearenospeakerwiresshorted
toanotherwireortothevehiclechassis
NoSound •RCASignal •CheckRCAconnectiontoheadunit
•Gaincontrolnotsetup •Ensureyouhavesetuptheampliergainlevelcontrol
•HeadUnit •Checkheadunitvolumelevel
•Amplier •Checkallpower,remoteonandgroundconnections
•Speakers •Checkspeakersforwireshorts
CROSSOVER TABLE
Model Channels Crossover Type Crossover Frequency Bass Boost
CA-AM10900 All Fixed-LPF LPFSelectable-80Hzor180Hz Selectable-0dBor12dB
CA-AM20350 All Selectable-LPF,HPF,orFULL LPFSelectable-80Hzor180Hz Selectable-0dBor12dB
HPFFixed-80Hz
CA-AM20650 All Selectable-LPF,HPF,orFULL LPFSelectable-80Hzor180Hz Selectable-0dBor12dB
HPFFixed-80Hz
CA-AM40700 Front Selectable-HPForOFF HPFFixed-80Hz None
Rear Selectable-LPForOFF LPFFixed-180Hz Selectable-0dBor12dB
CA-AM401200 Front Selectable-HPForOFF HPFFixed-80Hz None
Rear Selectable-LPForOFF LPFFixed-180Hz Selectable-0dBor12dB
Forfurtherproductandinstallationinformation,pleasevisitwww.fusionelectronics.com
Pourplusd’informationssurlesproduitsetl’installation,rendez-voussurwww.fusionelectronics.com
Paraobtenersinformacnacercadelosproductosydesuinstalacn,visiteelsitiowebwww.fusionelectronics.com
Bezoekwww.fusionelectronics.comvoormeerproduct-eninstallatie-informatie.
WeitereProdukt-undInstallationsinformationenndenSieunterwww.fusionelectronics.com
Perulterioriinformazionisuiprodottielaloroinstallazione,potetevisitarewww.fusionelectronics.com
Для получения дополнительной информации о продуктах и установке зайдите, пожалуйста, на: www.fusionelectronics.com
  • Page 1 1
  • Page 2 2

Fusion CA-AM41200 User manual

Category
Car audio amplifiers
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI