Avery Berkel Monarch 9906 Operating instructions

Brand
Avery Berkel
Model
Monarch 9906
Type
Operating instructions
Monarch is a trademark of Avery Dennison Retail Information Services LLC.
Avery Dennison is a trademark of Avery Dennison Corp.
TC9906LTOI Rev. AA 8/10 2010 Avery Dennison Corp. All rights reserved.
OPERATING INSTRUCTIONS
These instructions are for the Monarch® 9906 printer using the internal liner take-up option.
Internal Liner Take-Up
Internal liner take-up must be used with peel mode. This feature collects the liner on a take-up
reel located inside the printer’s cover. Refer to the Operator’s Handbook for additional
information.
Follow the steps for loading supplies for peel mode from the Operator’s Handbook and then
follow these steps.
1. Press down on the exit cover tabs to open the exit cover on the front of the printer.
2. Remove the labels from the first 18 inches of the liner.
3. Position the liner take-up reel so the open notch is facing up.
4. Position the liner take-up core so the open slot is facing up. Line up the slot in the core
with the notch in the reel. Slide the empty liner take-up core on the liner take-up reel.
5. Feed the liner over the peel bar, under the peel roller, under the liner take-up core and
around in a counter-clockwise direction.
6. Place the end of the liner in the take-up core’s opening.
Note: Fold the edge of the liner to easily insert it in the core’s open slot.
O
p
en Notch
O
p
en Slot
Supply
Liner
Liner
Liner Take-up Reel
Liner Take-up Core
2 Internal Liner Take-up Operating Instructions
7. Hold the liner in place while turning the take-up reel in a counter-clockwise direction to
remove slack in the supply liner.
8. Close the printhead assembly until you hear it click in to place.
9. Close the printer’s cover.
10. Close the exit cover.
11. Press FEED to position the supply under the printhead.
Removing a Full Liner Take-Up Roll
Remove the liner take-up when the printer alerts you of a full roll. The liner take-up reel holds
half of a roll of supply. Refer to the Operator’s Handbook for additional information.
1. Open the cover.
2. Unlock the printhead assembly by turning the retaining latch.
3. Press down on the exit cover tabs to open the exit cover on the front of the printer.
4. Use scissors to cut the liner in front of the take-up reel.
5. Gently pull the full liner take-up core off the reel.
Note: Place your fingers between the take-up core and printer wall. Gently push the core off
the reel. This eases removal and minimizes the liner telescoping from the reel.
6. Remove the liner from the take-up core.
7. Reload supply and continue printing.
Cut Liner Here
  • Page 1 1
  • Page 2 2

Avery Berkel Monarch 9906 Operating instructions

Brand
Avery Berkel
Model
Monarch 9906
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents