ASSEMBLY INSTRUCTIONS
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
1.(SEE FIGURE 1) Attach medium-sized bucket (B) to Large-sized bucket (C) with nuts (E) Insert the
2 screws under B into the small pre-drilled holes in the beam of C before the attached.
2. Insert pipe (F) into the pre-drilled hole in the beam of the medium-sized bucket (B). Attached the
small-sized bucket (A) to the medium-sized bucket (B), insert the two screw under (A) to the small
pre-drilled hole in the beam of (B) before the attached.
FIGURE 1
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
A 1Small-sized bucket
B
1
Medium-Sized bucket
C
1
Large-sized bucket
D
1
Electric Pump
E
F
4
6mm Nut(OD)
Pipe
G
1*
Plastic pipe
1*
A
C
B
E
E
G
D
Caution: Do not over tighten fasteners.
Pump Care & Maintenance
1. Do not plug in pump before filling container with water. Doing so may damage pump.
2. Use distilled water, if possible to fill container.
3. To adjust speed of water flow: unplug pump, remove lid, move switch on pump (E)
toward " +" positive to increase water flow, or " -" to decrease water flow.
4. Check water level periodically, add water if necessary.
5. If water is not flowing, check pump (E) or fountain assembly (A) for clogs. Pump may
build up calcium after a long period of time and stop running when tap water is used.
Any calcium remover can be used to clean pump.
F
F
D
G
3. Insert the electric pump in large sized bucket (C), join the pipe (F), when electricity goes through,
water can be pumped up automatically.
Read and understand all safety and operating instructions. Failure to follow all
instructions listed as well as good common sense practices may result in electric shock,
property damage, fire, and/or serious personal injury.
ELECTRICAL SAFETY INSTRUCTIONS
Grounding instructions
This fountain must be plugged into a 3-wire, 3-prong outlet that is properly working and has
been installed and grounded in accordance with all local, state or Federal codes and ordinances.
DANGER: Failure to connect this tool to a properly grounded outlet can result in DAMAGE, FIRE,
ELECTRIC SHOCK or FATAL INJURY. Consult a qualified electrician if you are in doubt as to whether
the outlet is properly grounded. Do not modify the plug provided with the product - if it will not fit
the outlet; have a proper outlet installed by a qualified electrician. Do not use any type of adapter
with this product.
WARNING
ED GF
C
BA
* These parts are attached to the bucket. They are not loose components of hardware package.