2. Gleason Reel
  3. ACA/ACC Cord Reels

Gleason Reel ACA/ACC Cord Reels Installation guide

  • Hello! I've reviewed the instructions for changing the roller guide position on your Gleason Reel ACA/ACC cord reels. This document details how to adjust the roller guide for a vertical lift application by removing/loosening screws, rotating the guide and securing it in a new position. I'm ready to assist with any questions you might have.
  • What is the purpose of this document?
    What is the initial roller guide position?
    When should I change the roller guide position to vertical?
    What steps are involved in changing the roller guide position?
xxxxxxxxx
Features
• xxxxxxxxxxxxxxxxxxxxxxxxxx
1. Completely remove the (2) inner screws. 2. Just loosen the (2) outer screws, keeping
the clamp plate attached to the roller guide.
3. Remove and rotate roller guide and move to
alternate location on the vertical frame for a
vertical up position. (This position would be used
if you are hanging your reel from the ceiling, for
a lifting application)
4. Re-tighten the (2) outer screws to
clamp the roller guide in place.
5. Re-assemble the (2) inner screws, and
tighten as required.
Your cord reel is now ready to be used with the roller guide located in the Lift position, for hanging the
cord reel from the ceiling.
Your cord reel is being supplied to you with a Horizontal payout roller guide. You may need to change
the position of your roller guide, depending on your application.
Instructions for changing roller guide position
Model ACA/ACC Cord Reels
GL_ACA_ACC INSTR SHT rev1
1/2021
Gleason Reel Corp.
600 South Clark St.
Mayville, WI 53050
920-387-4120
www.hubbell.com/gleasonreel/en
GR630614
/