Astonica 50101043 User manual

Astonica
Brand
Astonica
Model
50101043
Type
User manual

This manual is also suitable for

Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
Limited Warranty
World Factory, Inc.
®
Products for Home Use
World Factory, Inc.
®
(Seller) warrants to the original Buyer only, that each Astonica
®
Product will be
free from defects in material and workmanship for a period of one (1) year from date of purchase.
SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED
WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH
ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE
SELLER WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY
FROM REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER
MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This
warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to
normal use or weathering. To make a claim under this Limited Warranty, you must return the complete
product with proof of purchase, transportation prepaid, to any World Factory, Inc.
®
authorized service
center. Call 1-888-424-3354 for the location of the nearest authorized service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1)
YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR
LOSS OF PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if
such invalid and/or unenforceable provision had never been contained herein.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all
prior agreements, arrangements, or understandings between the parties relating to product warranty.
®
Made in China
©2005 World Factory, Inc.
Distributed by:
World Factory, Inc.
Coppell, TX 75019
Model No: 50101043
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
Star Blossom Bench
Instruction Manual
220805rev2
NOTE: This product is intended for residential, non-commercial use.
For warranty information, please refer to the back page of
this instruction manual.
ASSEMBLY INSTRUCTIONS
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
CAUTION: Do not over tighten fasteners.
Figure 1
1.(SEE FIGURE 1) Attach front wood slat (C)
with rounded edge facing out towards
the cast iron sides (B). Secure using two
round head screws (E), two washers (F),
and two nuts (G).
Repeat this step and attach rear slat (C).
Do not tighten at this time, leave
slats loose for adjustment later.
2.(SEE FIGURE 2) After attaching front and
rear wood slats (C) to cast iron sides (B),
attach backrest (A) to cast iron sides (B),
using four round head screws (E),
four washers (F), and four nuts (G).
Do not tighten at this time, leave the slats
and backrest loose for adjustment later.
Do not install plastic nut covers (I) at this
time, they should be installed after all
hardware has been tighten securely.
3. Attach the remaining four wood slats (C)
to cast iron sides (B) in the same method
as Step 1.
Do not tighten at this time, leave slats
loose for adjustment later.
4. 
Adjust the legs on the cast iron sides (B)
to a 90-degree angle and space out
wood slats (C) evenly.
Tighten all hardware securely.
5.(SEE FIGURE 3) Attach middle support
bracket (D) to the bottom of the wood
slats (C) using six self-tapping wood
screws (H).
6. (SEE FIGURE 2) Place the four plastic
nut covers (I) on the four nuts (G)
protruding from the back
of the backrest (A).
B
A
C
D
E
F
G
H
I
A
E
E
G
H
G
H
C
E
B
F
G
Figure 3
D
C
H
Figure 2
C
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
A 1Arched Bench Back
B 5Wood Seat Slats
C 2Cast Iron Legs with Wood Armrest
D 1
Middle Support Bracket
6mm x 32mm Bolt
E
14
6mm Washer
F 14
6mm Nut
G 14
Phillips Wood Screw
H
Plastic Nut Cover
I
5
4
I
1
2
NOTE: This product is intended for residential, non-commercial use.
  • Page 1 1
  • Page 2 2

Astonica 50101043 User manual

Astonica
Brand
Astonica
Model
50101043
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents