Audioplex AUDIO LEVELIZER Installation guide

Power Supply: 16 VAC (included)

Connectors: RCA type connectors

Switch: 2 position rotary by-pass switch

Frequency Response: 70 Hz - 20 KHz +/- 1dB

Total Harmonic Distortion: Less than 1% @ 100 Hz / Less than 0.05% @ 1 KHz

Input Impedance: 10 K

Size: 7.125"W x 2.125"H x 4.5"D

Weight: 3 lb.

The AUDIO LEVELIZER(tm) maintains a constant average output loudness, regardless of the audio source type or volume level.

This is perfect for taming those louder than program commercials on radio and TV, and volume variations between different broadcasting

stations, records and CD's (perfect for multi-disk players).

The AUDIO LEVELIZER(tm) can be connected in the tape monitor loop of any Hi-Fi receiver, between the preamp and audio

power amplifier, or between the audio outputs of a TV tuner or VCR and the stereo inputs of the audio system.

Normal sound dynamics and frequency response are maintained, while those annoying sounds are tamed to a level more

compatible with normal program content.

Your AUDIOPLEX TECHNOLOGY AUDIO LEVELIZER(tm) is covered by a lifetime warranty against any defects in

workmanship and materials. Any defects will be remedied without charge for labor or parts.

Damage incurred by shipping or by accident is not considered to be a defect, and not covered by this warranty. AUDIOPLEX

TECHNOLOGY is not responsible for defective operation caused by abuse or by modification or service by any unauthorized person or

agency.

The unit must be properly installed and operated according to instructions for the warranty to apply. Any necessary servicing

must be done by AUDIOPLEX TECHNOLOGY. The unit must be shipped with the proof of purchase and in the original carton and

packing materials to avoid damage.

This warranty gives you specific legal rights. You may have other rights which vary from state to state.

OUTPUT

INPUT

MADE IN USA

INSTALLATION MANUAL

TECHNOLOGY