Adam Sub8 Operating instructions

Category
Subwoofers
Type
Operating instructions

Adam Sub8 is a high-quality active subwoofer designed to deliver powerful and accurate bass reproduction. With a frequency response ranging from 28Hz to 150Hz, it can extend the low-end capabilities of any audio system. The Sub8 features a built-in amplifier that provides 160W of RMS power and 240W of peak power, ensuring ample headroom for even the most demanding applications. It has both balanced XLR and unbalanced RCA inputs, making it compatible with a wide range of audio sources.

Adam Sub8 is a high-quality active subwoofer designed to deliver powerful and accurate bass reproduction. With a frequency response ranging from 28Hz to 150Hz, it can extend the low-end capabilities of any audio system. The Sub8 features a built-in amplifier that provides 160W of RMS power and 240W of peak power, ensuring ample headroom for even the most demanding applications. It has both balanced XLR and unbalanced RCA inputs, making it compatible with a wide range of audio sources.

2
Introduction
First of all, we would like to thank you for choosing ADAM Audio!
ADAM Studio Subwoofers are built to a maximum in reproduction quality and perfection. To
enjoy the capabilties of your new subwoofer please read the following hints and considera-
tions, as the positioning and the acoustical properties of the control room often play a bigger
role than you might think.
General recommendations for the Setup:
• Thesubwoofershouldbepositionedonarmground.Vibratingpartscanmaskthesound;
there is not necessarily a clear distortion to be heard.
• Itisrecommendedtopositionthesubwooferbetweenthefrontspeakers,ifpossiblewith
a minimum distance of 20cm to the back wall.
• Avoid topositionthesubwooferina corner.Due toa resulting physicalpeakin the
frequency response there will always be a tendency for resonances and boominess.
Transportation
Ifyouhavetosendyoursubwoofertoanyotherlocationitisofvitalinteresttohavethe
originalpackagingmaterials.Experienceshowsthatitisverydifculttoavoiddamagesif
youhavetosendthemwithoutthesematerials.Wewillnotberesponsiblefordamagesdue
to improper packaging.
Wehopeverymuchthatyouenjoyyournewsubwooferanditsuniquesoniccapabilities.If
therearequestionspleasedonothesitatetocontactus-wewillbehappytoadviceyou.
The ADAM people.
Table of contents
SafetyInstructions 3
Quick Start 4
Controls ans Connectors 5-7
Limited warranty 8
Technical Data 9
English
3
Safety Instructions
Incaseofaproblem,pleaseeithercontactyourADAMdealerorus.Wearehappytotryand
help.Alwaysreferservicingtoqualiedpersonnelandneverattempttorepairthisproduct
by yourself. Please read through the following safety instructions completely before setting
your system up.
• Donotopenthesubwoofer.Therearenouser-serviceablepartsinside.
• Donotexposethisproducttorainormoisture,neverwettheinsidewith
anyliquidandneverpourorspillliquidsdirectlyontothisunit.
• Neveruseammableorcombustiblechemicalsforcleaningaudio
components
• Avoidtouchingthespeakermembranesanddonotblockthewoofer’s
ventilationports.
• Assurefreeairowbehindthespeakerstomaintainsufcientcooling.
• Alwaysusefullycheckedcables.Defectivecablescanharmyourspeakers.
They are a common source for any kind of noise, hum, crackling etc.
• Alwaysswitchoffyourentiresystembeforeconnectingordisconnecting
any cables, or when cleaning any components.
• Thisproduct,aswellasallattachedextensioncords,mustbeterminated
withanearthgroundthree-conductorACmainspowercord.Toprevent
shock hazard, all three components must always be used.
• Neverreplaceanyfusewithavalueortypeotherthanthosespecied.
Neverbypassanyfuse.
• Neverexposethisproducttoextremelyhighorlowtemperatures
• Neveroperatethisproductinanexplosiveatmosphere.
• Alwayskeepelectricalequipmentoutofthereachofchildren.
• Alwaysunplugsensitiveelectronicequipmentduringlightningstorms.
4
Quick Start
•After having unpacked your subwoofer, please allow the system to acclimate to the
temperature of the room. Please do not connect the subwoofer for approximately an
hour.
•Makesurethepowerswitchatthecontrolpanelisturnedoff.
•Decrease the volume of your audio system to protect your speaker and ears from
damage when switching the system on.
•Connecttheprovidedpowercordtothesubwoofer.
•Connectthesubwooferwithyou’reaudiosystemviaXLR(1)-orChinchinput(2).
•Switchpoweronatthecontrolpanel.Byincreasingthevolumefromyour audio sys-
tem, you should now hear sound.
•Toachievethebestpossiblesoundreproduction,please seethefollowingconsidera-
tions for speaker placement.
(1) (2)
English
5
Controls on the Frontpanel
Volume:
InputSensitivitycontrolfrom-60dBto+6dBrelativeto775mVwhenusedvia
thesymmetricalXLRinputorrelativeto250mVwhenusedviatheasymmetrical
Cinch(RCA)input.
Frequency:
Theupperfrequencylimitoftheunitisvariableandcanbesettoanyvalue
between50and150Hz.The85Hzmarkerindicatestherecommendationof
Dolby®labsforsurroundsoundsettings.Inpracticeaslightlylowercrossover
frequencydeliverstighterbassresponse,fortypicalnear-mideldmonitorswe
recommenda10clockposition,meaning70to75Hzasupperlimitor,tobe
moreexact,-3dBpointinthefrequencyresponse.
Please note: these settings do not have a precise character, as different satel-
lites and different room acoustics lead to results that cannot be foreseen indeed.
In the majority of cases there is the danger of boominess, if you take the same say
85Hzforboththesatelliteandthesubwoofer.Somewhatsmallervaluesforthesubleadto
tighter and better controlled bass response.
6
Controls and Connectors on the Backpanel
Mode
ThispushbuttongivesachoicebetweenSignal On: woofer starts operation as
soonasamusicalsignal arrives,andstopsafter15minuteswithoutasignal.
Continous: the unit is always working.
Werecommendthe”SignalOn”positionthatminimisespowerconsumptionand
hasprovedtobepracticalthatwayasyoudonotneedtolookforthemainpower
switch any more.
Phase Switch
WiththePhaseswitchyoucanalterthephaseoftheSub8relativetothesatellites.
Practically it means you change the polarity of the bass unit. Depending on the
distancebetweenwooferandsatellites0°or180°maybethebetterposition.
Thereisno“right”or“wrong”position,youhavetondoutbyyourselfwhatsounds
better, more exactly and more homogeneous in the low end.
English
7
Controls and Connectors on the Backpanel
Input - Balanced and Unbalanced
Thesestereojacks-XLRinthebalanced(alsonamed:sym-
metrical), Cinch or RCA in the unbalanced (also named:
asymmetrical)case,shouldbeconnectedtotheoutputof
your mixing console or stereo/surround sound system.
Satellite out - Balanced and Unbalanced
Thesejacksshouldbeconnectedtotheinputsofyouractive
studiomonitorsortheinputsofapowerampthatdrivespas-
sivemonitors.Thesignalissimultaneouslyavailablefromall
connectors.
Final recommendation:
After using the set up a few times we recommend to test the position of the controls again.
Inmostcases,whentheexcitementaboutthenewbottomhasbecomeless,youprefera
solutionwithlessbasslevel,andfromourexperiencethiswillbethemorecorrectone.
Satellite Filter
Thesatellitesinsuchasystemcanbedrivenfullrangeorwitha85Hzhigh
pass as recommended by Dolby® laboratories for use in surround set-ups.
Recommendation:IfpossiblegowiththemainsignaltotheSub8rstand
connectyoursatellitestotheSub8output,beitXLRsymmetricalorRCAasym-
metrical.Topreventthesatellitesfromthelowfrequenciesinmostcasesleadstoabetter
soundfromyoursatellites,astheydonothavetodeliverthebigamplitudes.Oftenclarity
anddynamicrangeofthesespeakersareimprovedthatway.
Attention! If you switch the filter in or out, it often becomes necessary to switch the
phase as well - try it out please!
8
d)
a)
b)
c)
e)
Warranty
ADAMAudioGmbHprovidesafive year limited warranty for this product.
Terms and Conditions
This warranty is limited to the repair of the equipment or, if necessary, the
replacement of parts or the product and return shipping within the country
of purchase.
This warranty complements any national/regional law obligations of deal-
ers or national distributors and does not affect your statutory rights as a
customer.
Neitherothertransportation,noranyothercosts,noranyriskforremoval,
transportationandinstallationofproductsiscoveredbythiswarranty.
Productswhoseserialnumberhavebeenaltered,deleted,removedormade
illegible are excluded from this warranty.
The warranty will not be applicable in cases other than defects in materials
and/orworkmanshipatthetimeofpurchaseandwillnotbeapplicable:
for damages caused by incorrect installation, connection or packing,
for damages caused by any use other than correct use described in the user
manual,
for damages caused by faulty or unsuitable ancillary equipment,
ifrepairsormodicationshavebeenexecutedbyanunauthorizedperson,
fordamagescausedbyaccidents,lightning,water,reheat,publicdistur-
bances or any other cause beyond the reasonable control of ADAM Audio.
How to claim repairs under warranty
Shouldserviceberequired,pleasecontact the ADAM Audio dealer where
the product has been purchased.
Iftheequipmentisbeingusedoutsidethecountryofpurchase,theinterna-
tionalshippingcostshavetobepaidforbytheowneroftheproduct.
ServicemaybesuppliedbyyourADAMAudionationaldistributorinthecoun-
tryofresidence.Inthiscase,theservicecostshavetobepaidforbythe
owner of the product whereas the costs for parts to be repaired or replaced
arefreeofcharge.Pleasevisitourwebsitetogetthecontactdetailsofyour
local distributor.
Tovalidateyourwarranty,youwillneedacopyofyouroriginalsalesinvoice
with the date of purchase.
English
9
Technical Data
Technical data Sub8
Basketø 8.5“/210mm
Voicecoilø 1.5“/38mm
Cone material coated Paper
Input connectors
analog XLR/RCA
Built-in Amplifiers
Subwoofer 1
Amp.powerRMS/music
1/2
160W/240W
General
Frequency response 28Hz-150Hz
THD>60Hz ≤1%
MaximumpeakSPLin1mhalfspace ≥110dB
Crossoverfrequencies 50-150Hz
Inputimpedance 10kΩ
Weight 12kg(26.5lb.)
Magnetically shielded no
HeightxWidthxDepth 410x260x380mm(16“x10“x15“)
Warranty 5 years
*1 = long term IEC 265-8-Wrms / 10 min
*2 = nominal IEC 265-8 = Peak Power 5 µsec
ADAM Audio GmbH
Ederstr.16
12059Berlin
GERMANY
tel:+4930-8630097-0
fax:+4930-8630097-7
email:[email protected]
ADAM Audio UK Ltd.
ADAM Audio USA Inc.
ADAM Audio China
www.adam-audio.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20

Adam Sub8 Operating instructions

Category
Subwoofers
Type
Operating instructions

Adam Sub8 is a high-quality active subwoofer designed to deliver powerful and accurate bass reproduction. With a frequency response ranging from 28Hz to 150Hz, it can extend the low-end capabilities of any audio system. The Sub8 features a built-in amplifier that provides 160W of RMS power and 240W of peak power, ensuring ample headroom for even the most demanding applications. It has both balanced XLR and unbalanced RCA inputs, making it compatible with a wide range of audio sources.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages